Advertisement
3
Check the car's wiring carefully and connect
them to the supplied standard connector.
1
Green/black strip Left speaker (Rear)
2
White/black strip Left speaker (Front)
3
Gray/black strip
4
Purple/black strip Right speaker (Rear)
e
RED
Ignition key +12V DC when
ON/ACC
f
BLUE
Motor/electric antenna relay
control lead
g
BLACK
Ground
h
YELLOW To the +12V car battery which
is energized at all times
4
Connect the supplied standard connector to
the unit.
F
Tip
The pin arrangement for the ISO connectors
depends on the type of vehicle you drive. Be
sure to make proper connections to prevent
damage to the unit.
Mount into the dashboard
1
If the car does not have an on-board drive or
navigation computer, disconnect the negative
terminal of the car battery.
If you disconnect the car battery in a car
that has an on-board drive or navigation
computer, the computer may lose its
memory.
If the car battery is not disconnected, to
avoid short-circuit, ensure that the bare
wires do not touch each other.
2
Ensure that car dashboard opening is within
these measurements:
3
Remove the two screws on the top of the
unit.
H
4
Remove the mounting sleeve with the
supplied disassembly tools.
5
Install the sleeve into the dashboard and
Right speaker (Front)
G
I
J
Note
E
supplied screws, skip this step.
6
Place the supplied rubber cushion over the
end of the mounting bolt.
7
Slide the unit into the dashboard until you
hear a click sound.
8
Reconnect the negative terminal of the car
battery.
Attach the front panel
1
Attach the trim plate.
2
Insert the right side of the panel in the
chassis until it is correctly engaged.
3
Press the left side of the panel until the
mechanism locks it into place.
K
L
M
N
Advertisement
