Advertisement
English
These instructions are for a typical installation.
However, if your car has different requirements,
make the corresponding adjustment. If you have
any questions regarding installation kits, consult
your Philips car audio dealer.
Caution
This unit is designed for negative ground
(earth) 12 V DC operation only.
Always install this unit in the car dashboard.
Other locations can be dangerous as the rear
of the unit heats up during use.
To avoid short-circuit: before you connect,
ensure that the ignition is off.
Ensure that you connect the yellow and red
power supply leads after all other leads are
connected.
Ensure that all loose leads are insulated with
electrical tape.
Ensure that the leads do not get caught under
screws orin parts that will move (e.g. seat rail).
Ensure that all ground (earth) leads are run to
a common ground (earth) point.
Use only the supplied mounting hardware for
a safe and secure installation.
When you need to change the fuse, consult a
professional.
Note on the power supply lead (yellow)
When you connect other devices to this
apparatus, ensure that the rating of the car
circuit is higher than the total fuse value of all
the connected devices.
Notes on speaker connection
Never connect speaker wires to the metal
body or chassis of the car.
Never connect speaker wires with stripes to
one another.
Connection: for cars with ISO connectors
Caution
Ensure that all loose leads are insulated with
electrical tape.
1
Pull out the ISO connectors from car
dashboard and connect them to the bigger
end of the supplied standard connector.
2
Connect the other end of the supplied
standard connector to the unit.
3
illustrated, if applicable. You can connect the
RCA cables (not supplied).
Connector
1
ANTENNA
2
FRONT LINE
OUT R (Socket)
3
FRONT LINE
OUT L (Socket)
4
REAR LINE
OUT R (Socket)
5
REAR LINE
OUT L (Socket)
6
SUBWOOFER
Connection: for cars without ISO
connectors
Caution
Be sure to connect the black ground (earth)
1
illustrated, if applicable.
Connector
1
ANTENNA
2
FRONT LINE
OUT R (Socket)
3
FRONT LINE
OUT L (Socket)
4
REAR LINE
OUT R (Socket)
5
REAR LINE
OUT L (Socket)
6
SUBWOOFER
2
Cut off the bigger end of the supplied
standard connector.
A
B
C
Connect to
Antenna
Front right speaker
Front left speaker
Rear right speaker
Rear left speaker
Subwoofer
D
Connect to
Antenna
Front right speaker
Front left speaker
Rear right speaker
Rear left speaker
Subwoofer
Advertisement
