Access The System Remotely - Dell C Series Quick Start Manual

Systems
Hide thumbs Also See for C Series:
Table of Contents

Advertisement

Access the System Remotely

You can configure the system to access it remotely by Telnet.
The systems have a dedicated management port and a management routing table
that is separate from the IP routing table.
Configuring the system for Telnet is a three-step process:
Step
Task
Configure an IP address for the management port.
1
Configure a management route with a default gateway.
2
Configure a username and password.
3
Configure the Management Port IP Address
Assign IP addresses to the management ports.
NOTE: Assign different IP addresses to each RPM's management port.
Step Task
Enter INTERFACE
1
mode for the
Management port.
Assign an IPv4 or
2
IPv6 address to the
interface.
Enable the interface.
3
Configure a Management Route
Define a path from the system to the network from which you are accessing the
system remotely. Management routes are separate from IP routes and are only
used to manage the system through the management port.
Command Syntax
interface ManagementEthernet
slot/port
ip address {ipv4-address | ipv6-
address}/mask
no shutdown
Command Mode
CONFIGURATION
INTERFACE
INTERFACE
Installing the Software
23

Advertisement

Table of Contents
loading

This manual is also suitable for:

C7004C7008

Table of Contents