1. Manuals
  2. Brands
  3. CTC Parker Automation Manuals
  4. Desktop
  5. PC9
  6. Replacement

CTC Parker Automation PC9 Replacement

Cd-rom replacement
Hide thumbs Also See for PC9:
1
2
3
4
5
6

Advertisement

Table of Contents

P C 9 / P 9 C D - R O M R e p l a c e m e n t

Introduction

These instructions explain how to replace a CD-ROM drive in the PC9
Industrial PC or P9 PowerStation. They include steps for disassembling
the unit, removing a previously installed drive, installing a new drive, and
Warning
Warning
To complete this procedure, you will need the following items:
•
•

Disassembling the Unit

To disassemble the unit, follow these steps:
1. Turn off the unit.
2. Disconnect the unit from the power source.
3. Disconnect all cables attached to the unit.
4. Remove the two screws securing the backshell to the faceplate as-
sembly, as shown below.
CTC Parker Automation
For safety reasons, the unit should be opened only by qualified
service personnel.
Be sure to observe electrostatic discharge (ESD) precautions
while working inside the unit.
CD-ROM Replacement Kit for PC9/P9 (CDR-9000)
Phillips-head screwdriver
Remove
these
screws
A3-06021-100

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PC9 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for CTC Parker Automation PC9

Summary of Contents for CTC Parker Automation PC9

  • Page 1 P C 9 / P 9 C D - R O M R e p l a c e m e n t Introduction These instructions explain how to replace a CD-ROM drive in the PC9 Industrial PC or P9 PowerStation. They include steps for disassembling the unit, removing a previously installed drive, installing a new drive, and reassembling the unit.
  • Page 2 PC9/P9 CD-ROM Replacement 5. Swing the backshell away from the faceplate. 6. Detach the three cables connecting the faceplate assembly and backshell. These cables are shown below. Detach the Detach the Monitor card backlight cable monitor cable here here MAINTENANCE...
  • Page 3 PC9/P9 CD-ROM Replacement Remove this bracket Warning Make sure that both the faceplate assembly and backshell are supported when you remove the safety bracket and when you open the backshell. 8. Lift the backshell off its hinges, and place it on a static dissipative mat in a location free from dirt and moisture and protected against static discharge.
  • Page 4 PC9/P9 CD-ROM Replacement Remove these screws CD-ROM drive Disconnect cables here Remove these screws Slide CD-ROM drive out of the unit to the left 2. Disconnect the power and data (ribbon) cables attached to the CD- ROM drive. Note Note where these cables are attached to the CD-ROM drive so that you can re-attach them to the new drive later.
  • Page 5 PC9/P9 CD-ROM Replacement Reassembling the Unit To reassemble the unit, follow these steps: 1. Replace the backshell on its hinges. Warning When lifting the backshell, grasp it from the outside. Be careful not to touch the monitor card, located inside the top of the main- tenance compartment.
  • Page 6 PC9/P9 CD-ROM Replacement CTC Parker Automation...

This manual is also suitable for:

P9 powerstation

Table of Contents