Cd Player - Philips AZ1565/17 User Manual

DIGITAL TUNER
Changing tuning grid (some versions only)
In North and South America the frequency step between adjacent
channels in the AM and FM band are 10 KHz and 100 KHz
respectively. In the rest of the world this step is 9 KHz and
50 KHz. Usually the frequency step has been preset in the factory
for your area.
1. Check that the set is in the TAPE/OFF position and switched
off.
2. To select 9KHz : Simultaneously, press PROG and REPEAT on
the set.
3. Switch the set on to TUNER and then release the controls.
• To select 10KHz : Repeat steps 1-3 but in step 2,
simultaneously, press PROG and TUNING § on the set.
™ When you tune to radio stations, the display shows tuning in
either steps of 9 or 10.
™ All preset stations will be affected and you may need
reprogram the preset stations.
Playing a CD
1. Select CD source.
2. Press OPEN•CLOSE to open the CD door.
™ Display:
when you open the CD door.
3. Insert a CD or CD-R(W) with the printed side facing up and
press OPEN•CLOSE to close the CD door.
™ Display:
as the CD player scans the contents of a CD.
The total number of tracks and playing time are then shown.
™ Display:
is shown if the CD R(W) is not finalised.
4. Press PLAY•PAUSE 2; (on the remote control 2;) to start
playback.
™ Display: Current track number and elapsed playing time of the
track during CD playback.
5. To interrupt playback press PLAY•PAUSE 2;.
Press PLAY•PAUSE 2; again to resume play.
™ The display freezes and the elapsed playing time flashes when
playback is paused.
6. To stop CD playback, press STOP 9
Note: CD play will also stop when:
– the CD door is opened;
– the CD has reached the end (unless you have selected
REPEAT ALL);
– you select another source: TAPE / TUNER.
Selecting a different track
• Press SEARCH ∞ or § on the set, (on the remote control ¡
or ™) once or repeatedly until the desired track number
appears in the display.
12

CD PLAYER