Philips AZ1226/05 User Manual

MP3-CD Soundmachine
User manual
Manuel d'utilisation

Manual del usuario

Benutzerhandücher
Important notes for
AZ1226
users in the U.K.
Mains plug
This apparatus is fitted with an approved 13
Amp plug.To change a fuse in this type of
plug proceed as follows:
1. Remove fuse cover and fuse.
2. Fix new fuse which should be a BS1362
5 Amp, A.S.T.A. or BSI approved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your
socket outlets, it should be cut off and an
appropriate plug fitted in its place. If the
mains plug contains a fuse, this should have
a value of 5 Amp. If a plug without a fuse is
used, the fuse at the distribution board
should not be greater than 5 Amp.
Note:The severed plug must be disposed
of to avoid a possible shock hazard should
it be inserted into a 13 Amp socket else-
where.
Environmental information
All unnecessary packaging material has been omitted.The packaging can be easily separat-
ed into three materials: cardboard, polystyrene and plastic.
Your set consists of materials which can be recycled if disassembled by a
specialized company. Please observe the local regulations regarding the
disposal of packaging, dead batteries and old equipment.
How to connect a plug
The wires in the mains lead are coloured
with the following code: blue = neutral (N),
brown = live (L). As these colours may not
correspond with the colour markings identi-
fying the terminals in your plug, proceed as
follows:
• Connect the blue wire to the terminal
marked N or coloured black.
• Connect the brown wire to the terminal
marked L or coloured red.
• Do not connect either wire to the earth
terminal in the plug, marked E (or e) or
coloured green (or green and yellow).
Before replacing the plug cover, make cer-
tain that the cord grip is clamped over the
sheath of the lead - not simply over the
two wires.
Copyright in the U.K.
Recording and playback of material may
require consent. See Copyright Act 1956
and The Performer's Protection Acts 1958
to 1972.