Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Manual
General information
This quick installation guide gives a rough overview and helps to quickly start with basic steps. Please read the
supplied instruction manual for detailed information.
Power
1
Check whether the power voltage as shown on the type plate corresponds to your local power voltage.
If it does not, consult your dealer or service organisation.
2
After all connections have been made, connect the power cord to AC MAINS~ and to the wall outlet.
This switches on the AC power supply.
To disconnect the set from the power completely, remove the power plug from the wall outlet.
Basic audio setup
Connect :
1
Power cord A
2
FM wire antenna B
3
AM loop antenna C
4
Speakers D
5
Insert batteries into remote control.
You can now already listen to music from the sources TUNER
and CD!
Prerequisites for the home network setup
1
Connect your PC, gateway router and broadband modem
(cable/DSL) according to the router's setup instructions.
2
Configure your gateway router following the directions
specified in your router's manual and make sure that the PC's
Internet connection is installed properly and working. If you
have problems with the setup of the Internet connection,
contact your networking equipment manufacturer.
IMPORTANT!
Do not connect the streamium MC-i200 to the gateway router before the
internet connection of the connected PC through the router is working.
Connecting Streamium MC-i200 to the Internet
through a gateway router
3
After the Internet connection has proven to be working,
connect the MC-i200 to the gateway router with the
supplied cable.
4
Press CONNECT.
Depending on your network setup, you might have to enter network
configuration data. Please follow the instructions on the system's display, using
the Navigation Jog, the OK/PLAY (É) and the numerical / alphabetical keypad on
the remote control to enter the requested connection information.
Getting Started
Getting Started
MC-i200
MC-i200
C
B
FM
speaker
AM
D
(right)
gateway
router
DSL or
cable modem
from RJ45
data
port
ECO POWER
NAVIGATE
PLAY
INCR. SURR.
SLEEP
DIM 123
SHUFFLE
REPEAT
•
•
VIEW
softkeys
•
OK
BACK
Navigation Jog
OK/PLAY
RESUME
OPTIONS
CONNECT
PC-LINK
CD
OPTIONS
CONNECT
A
speaker
(left)
INTERNET
FAVORITES
FAVORITES
ALL
MW LW
AMFM
NEWS
REC
1 2 3
•
ENTER
CANCEL
TUNER
AUX
iR
OPEN/
CLOSE
Advertisement
Table of Contents
Related Manuals for Philips MC-I200/21M
Summary of Contents for Philips MC-I200/21M
- Page 1 MC-i200 MC-i200 General information This quick installation guide gives a rough overview and helps to quickly start with basic steps. Please read the supplied instruction manual for detailed information. Power Check whether the power voltage as shown on the type plate corresponds to your local power voltage. If it does not, consult your dealer or service organisation.
- Page 2 Press OK / PLAY (É) again to install all available radio stations. Use the Navigation Jog to scroll through the list of radio stations. Press OK/ PLAY (É) to select the radio station. For more information, read the user manual or go to: http://My.Philips.com • OPTIONS CONNECT •...
- Page 3 i200 i200 Streamium Micro Hi-Fi System 3139 115 21561...
- Page 4 As new services and features are continuously added to this product through our online upgrades, the documentation included may not be up-to-date. Please refer to My.Philips.com for the most recent information. MISES À NIVEAU De nouveaux services et de nouvelles fonctions sont ajoutés régulièrement à...
- Page 5 M I C RO H I F I S YS T E M STANDBY•ON ECO POWER NAVIGATE INCR. SURR. • • VIEW • OPTIONS CONNECT SOUND JOG TREBLE BASS PLAY FAVORITES FAVORITES SLEEP DIM 123 SHUFFLE REPEAT MW LW AM FM NEWS 1 2 3 BACK...
- Page 6 ATENCIÓN Microsistema de Audio MC-i200/21 110–127 / 220–240V~; 50–60 Hz 80 W Philips Mexicana, S.A. de C.V. Norte 45, # 669, Col. Industrial Vallejo Tel. 5728-4200 Philips Electronics HK, Ltd. ______________________________ CAUTION operation.
- Page 7 Index English ------------------------------------------------ 6 Français -------------------------------------------- 35 Español --------------------------------------------- 64 -------------------------------------------------------- 93 3139 115 21561...
-
Page 8: Table Of Contents
Proxy Configuration Network Information Product Information Disable Internet Software Upgrade Restore Defaults About “My.Philips.com” ... 20 CD/MP3-CD Operations Discs for playback ... 21 Loading disc ... 21 Basic operations ... 22 Selecting a desired track/passage ... 22 Repeat and Shuffle ... 22... -
Page 9: General Information
IMPORTANT! PLEASE NOTE THAT THE VOLTAGE SELECTOR LOCATED AT THE REAR OF THIS SYSTEM IS PRESET AT 220V FROM THE FACTORY. FOR COUNTRIES THAT OPERATE AT 110V- 127V, PLEASE ADJUST TO 110V-127V BEFORE YOU SWITCH ON THE SYSTEM. Environmental information All unnecessary packaging has been omitted. -
Page 10: Preparations
Preparations AM loop antenna speaker DIGITAL (right) LINE OUT WOOFER OUT SPEAKERS 6 Rear connections The type plate is located at the rear of the system. Power Before connecting the AC power cord to the wall outlet, ensure that the following are done; –... -
Page 11: Speakers Connection
Within a short period you will receive an E-Mail- INTERNET confirmation with your registration details. Follow the link displayed in the E-Mail to http://My.Philips.com, where you can customise your settings and download the PC-Link PC application. – For later modification of the connection settings, press CONNECT and OPTIONS followed by the soft key (! ) on the system to select “SET”... -
Page 12: Optional Connections
Preparations Optional connections The optional equipment and connecting cords are not supplied. Refer to the operating instructions of the connected equipment for details. Analogue audio connections AUX/CDR IN (R/L) Use a cinch cable to connect these terminals to the analogue audio out terminals of an external equipment (TV, VCR, Laser Disc player, DVD player or CD Recorder). -
Page 13: Controls
Controls Controls on the system and remote control STANDBY ON / ECO POWER – to switch the system on or to standby mode. – hold down to switch the system to Eco Power standby mode. Display screen – to view the current status of the system. VIEW –... - Page 14 Controls ≤ à / á for CD (play view)…to search backward/ forward. for Tuner ... to tune to a lower or higher radio frequency. – used as a soft keys, to select from the available choices on the bottom line of the screen. ∞...
-
Page 15: Basic Functions
M I C RO H I F I S YS T E M STANDBY•ON ECO POWER NAVIGATE PLAY INCR. SURR. SLEEP DIM 123 SHUFFLE REPEAT • • VIEW • BACK RESUME OPTIONS CONNECT PC-LINK IMPORTANT! Before you operate the system, complete the preparation procedures. -
Page 16: Switching The System On
Basic Functions Switching the system on In standby mode Press STANDBY ON to switch on the last selected source. Press PC-LINK, CONNECT, CD, TUNER, or AUX to select the desired source. In Eco Power Standby mode Press STANDBY ON on the system. Press PC-LINK, CD, TUNER, CONNECT or AUX on the remote control. -
Page 17: Sound Control
Sound control For optimal sound listening, you are only able to select BASS/TREBLE or wOOx at a time. wOOx There are three wOOx settings to enhance the bass response. Press wOOx repeatedly to select the next wOOx level or switch the wOOx effect off : wOOx 3, wOOx 2, wOOx 1 or wOOx OFF. -
Page 18: Screen Display
Basic Functions Screen display The system has two main screen display views – NAVIGATION and PLAY. Navigation view Allows you to navigate through the contents of the currently selected source/service. In some cases, there may exist more than one level of navigation. For example, selecting an item in the existing list may further generate a sub-list of the selected item. -
Page 19: Scrolling
Scrolling All lists in navigation view are sorted in alphabetical or numerical order. To scroll through a list Adjust the navigation jog clockwise to scroll down or anti-clockwise to scroll up. There are two scrolling speeds : 1slow and 2fast. Enables you to skip forward/backward to an item on the list. -
Page 20: Internet Audio
MP3 music from your PC via the home PC’s network. In order to enjoy the PC-Link, you have to install the PC-Link PC application. This application can be downloaded from “http://My.Philips.com”. Press PC-LINK. “S S S S S CANNING FOR PC’S CANNING FOR PC’S” is displayed. -
Page 21: Set Options
Set options An option menu exists for each source/service except for TUNER and AUX. The available option menus are detailed within the respective source/service sections in this manual. Press CONNECT followed by OPTIONS. Press the soft key (!) on the system to select “SET SET”. -
Page 22: Disable Internet
About “My.Philips.com” “My.Philips.com” provides a personal online tool for managing your entertainment choices. It is an exclusive service to owners of Philips’ premium internet-connected products. Once you have registered with “My.Philips.com”, you will be able to : – create and personalise your music selections. -
Page 23: Cd/Mp3-Cd Operations
NAVIGATE PLAY INCR. SURR. SLEEP DIM 123 SHUFFLE REPEAT MW LW • • VIEW • BACK RESUME CANCEL OPTIONS CONNECT PC-LINK IMPORTANT! – This system is designed for regular discs. Therefore, do not use any accessories such as disc stabiliser rings or disc treatment sheets. -
Page 24: Basic Operations
CD/ MP3-CD Operations Basic operations Playing a disc Press 2 . To interrupt playback Press Å . The current track time flashes. To resume playback, press Å again. To stop playback Press Ç. Selecting a desired track/passage To select a desired track –... -
Page 25: Marking Favorite Tracks
CD/MP3CD using their individual user ID. You can manage your CD/MP3-CD favourites in My.Philips.com (refer to “My.Philips.com” for more information). Use the navigation jog (or press 3 / 4 on the remote control) to scroll through the tracks. -
Page 26: Artist And Title Information
CD /MP3-CD Operations Artist and title information The system is able to display artist and title information such as CD title, artist’s name, musical genre, track titles and so forth (metadata). The tracks on the disc are displayed in numerical order when no CD information is available. -
Page 27: Radio Reception
NAVIGATE PLAY INCR. SURR. SLEEP DIM 123 SHUFFLE • • VIEW • BACK RESUME OPTIONS CONNECT PC-LINK Tuning to radio stations Press TUNER to select TUNER mode. "TUNER TUNER" is displayed. The current radio TUNER TUNER TUNER frequency will appear on the display. If an FM station is received in stereo, displayed. -
Page 28: Manual Preset Programming
Radio Reception Manual Preset Programming Tune to your desired radio station (refer to “Tuning to radio stations”). Press (UN)MARK ( ). The current station will be stored in the next available preset number. Repeat steps 1–2 to store other radio stations. Notes: –... -
Page 29: Personalised And Interactive Features
Personalised and interactive features Multiple users This system allows personalisation for multiple users. Your personal selections are bound to a user account. This feature is available for PC-LINK, CONNECT and CD only. Creating your user account Enter your e-mail address in the set options menu “SET REGISTRATION”. -
Page 30: External Sources
External Sources NAVIGATE PLAY FAVORITES INCR. SURR. SLEEP DIM 123 SHUFFLE REPEAT MW LW AM FM NEWS 1 2 3 • • VIEW • BACK ENTER RESUME CANCEL OPTIONS CONNECT PC-LINK TUNER This source enables you to connect external sound devices and play the sound through your system’s built-in speakers. -
Page 31: Clock/Timer
NAVIGATE PLAY INCR. SURR. SLEEP DIM 123 SHUFFLE • • VIEW • BACK RESUME OPTIONS CONNECT PC-LINK IMPORTANT! When in Eco Power standby mode, it is not possible to operate the clock or timer function. View clock The clock (if it is set) will be shown in standby mode. -
Page 32: Timer Setting
Clock/Timer Timer setting The system can switch on to CD, TUNER, CONNECT or PC-LINK mode automatically at a preset time, serving as an alarm to wake you IMPORTANT! – Before setting the timer, ensure that the clock is set correctly. –... -
Page 33: Sleep Timer Setting
Sleep timer setting The sleep timer enables the system to switch to standby mode automatically at a preset time. Press SLEEP on the remote control repeatedly to select a preset time. The selections are as follows (time in minutes): 15 ™ 30 30 ™... -
Page 34: Specifications
Specifications AMPLIFIER Output power 1500 W PMPO ... 2 x 50 W RMS Signal-to-noise ratio ... 70 dBA (IEC) Frequency response ... 50 – 16000 Hz, ± 3 dB Input sensitivity AUX In / CDR/DVD In ... 500 mV / 1V Output Speakers ... -
Page 35: Troubleshooting
WARNING Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. - Page 36 Troubleshooting GENERAL The system does not react when buttons are pressed. Sound cannot be heard or is of poor quality. The left and right sound outputs are reversed. The remote control does not function properly. The timer is not working. Not all buttons are lit.