Fujitsu ETERNUS LT140 User Manual page 15

Chapter 1 Overview
1.2 References for Setup
IMPORTANT
Refer
Refer
Refer
FUJITSU Storage ETERNUS LT140 Tape Library User's Guide -Server Connection-
Setting the LT140
Perform the settings for the LT140.
Change the topology setting to "Fabric (N/F)" or "Loop (L)". Set fixed values for the link speed
and the Loop ID/ALPA.
-
"Chapter 2 Setting the LT140" (page 22)
-
"2.2 Settings for Fibre Channel Connections" (page 22)
-
"2.2.1 Setting the Link Speed" (page 22)
-
"2.2.2 Setting the Topology and the Loop ID (for Direct Server Connections)" (page 23)
Setting the Operating System
Make settings for the HBA driver and the device driver.
-
"3.2 Linux" (page 28)
-
"3.2.1 Fibre Channel Connections/SAS Connections" (page 28)
Setting Backup Software
Apply patches, make settings for the robot driver, and set up the backup software.
•
Backup software used
-
NetBackup
•
"4.1 NetBackup" (page 34)
-
NetWorker
•
"4.2 NetWorker" (page 37)
-
IBM Spectrum Protect (IBM Tivoli Storage Manager)
•
"4.3 IBM Spectrum Protect" (page 38)
-
NetVault
•
"4.5 NetVault" (page 40)
Copyright 2019 FUJITSU LIMITED
15
P3AG-3752-03ENZ0