Connection; Connecting The Power Source; Connecting To 24V Ac Source; Connecting To The Network - Sony SNC-WL862 Installation Manual

Connection

Connecting the Power Source

There are two ways to supply the power source to
this camera, as follows.
• AC 24 V
• Power supply equipment pursuant to IEEE802.3at
(PoE+ * system)
* PoE means Power over Ethernet.
Depending on the requirements of your
installation site, select an appropriate power
source.
• Do not turn off the camera immediately after
turning it on. Wait for at least five minutes before
turning off the camera.
• Do not connect the power input cable if power is
supplied by a PoE system.
• The ambient temperature must be -30ºC or
higher at startup of the camera.
• When using the camera in a very low
temperature environment, the embedded heater
may take up to 10 minutes to warm up the
camera. When the temperature within the
canister reaches -10ºC, the camera automatically
starts.

Connecting to 24V AC source

Connect the power input cable of the camera to a
24V AC source.
• Use a 24V AC source isolated from 100V AC. The
usable voltage range is as follows. (Assured
range of the voltage the camera is receiving
(receiving-end voltage).)
24V AC: 21.6V to 26.4V
• Use a UL cable (VW-1style 10368) for this
connection.
The AWG #16 to #20 is recommended.
• Use the following plug when connecting from a
24V AC source.
AC plug: straight PL03B, 5.5 mm outer diameter,
2.1 mm inner diameter
• The AWG #26 or thicker is recommended for I/O
combo cable signals.

Connecting to the Network

Connect the Ethernet port of the camera to a router
or hub in the network using a commercially
available network cable (not supplied).

Assigning the IP address

1
Download the installer of "SNC toolbox" in the
appropriate folder from the download site.
2
Install the SNC toolbox.
Unzip the ZIP file of the downloaded installer.
Double-click "SncToolbox_Setup.exe."
For details on installing and use refer to the
Application Guide.
3
Assign an IP address to the camera.
Assign an IP address to the camera using the
installed SNC toolbox.
For details, see "Using SNC toolbox" - "Assign
an IP address" in the Application Guide.
Tip
SNC toolbox stands for Sony Network Camera
toolbox.
13