Warnings And Symbols; Warnings - Maytag MFS Series Programming Manual

2. WARNINGS AND SYMBOLS

2.1. WARNINGS

BEFORE OPERATING A MACHINE CONTROLLED BY AN ELECTRONIC PROGRAMMER, READ THIS
MANUAL. INCORRECT USE CAN RESULT IN SERIOUS INJURIES OR DAMAGE TO THE MACHINE
CONTROLS. IGNORING INSTRUCTIONS CAN CAUSE AN INCORRECT MACHINE FUNCTION, WHICH
MAY RESULT IN INJURIES OR MACHINE AND/OR LINEN DAMAGE.
– This manual version is an original English version. Without the original version these instructions are not
complete. Before installation, operating and maintenance of the machine, read complete instructions
thoroughly which means the following manuals: „Programming Manual", „User's Manual" and „Installation
and Maintenance Manual". Follow these instructions and keep them handy for later use.
– A machine must be installed by following the „Installation and maintenance manual". Before a machine is
started, it must be initialized and tested by a qualified installer . When operating the machine, follow the
machine „Users Manual".
– The electric service must not be affected by other electrical loading. A nominal voltage, if loaded or not
must work in the range ±10%, with a maximum permanent frequency deviation of 1% or a short-time one at
2% of a given frequency (50 or 60 Hz). Connecting or starting the machine at an incorrect voltage can
damage the controls.
– The machine must not be exposed to high humidity or extreme high and low temperatures.
– Do not tamper with the controls.
INSTRUCTIONS IN THIS MANUAL DO NOT COVER ALL DANGEROUS SITUATIONS.
IT IS UP TO THE USER TO HANDLE THE MACHINE CAREFULLY.
The manufacturer has the right to change specifications in this manual without prior notice. All the stated
information is only for informative purpose and must be considered as general. It is not possible to present all
the specific data of the device.
NOTE !!!
EVERY CIRCUIT BOARD HAS A SERIAL NUMBER AND THE PART NUMBER OF THE BOARD (Picture 8.3).
ON THE FLASH MEMORY CHIP ON THE CIRCUIT BOARD IS A LABEL SPECIFYING THE SOFTWARE
NUMBER AND VERSION AND/OR THE DATE OF THE SOFTWARE (Picture 8.3). THIS DATA, AS WELL
AS THE MODEL AND SERIAL NUMBER OF THE MACHINE, MUST BE MENTIONED IN ALL
CORRESPONDENCE OR INQUIRIES ADDRESSED TO THE DISTRIBUTOR OR MANUFACTURER.
2 PROGRAMMING MANUAL 516532 B PUBLICATION DATE 1 JUN 2007.DOC