Delay Times; Connecting Power Supply - Philips DVD962SA/001 Owner's Manual

Delay times

The SACD player is set to reproduce correctly
synchronized Digital Surround Sound in a listening area
where the surround speakers are about 150cm nearer to
the listening position than the front speakers, and the
center speaker is in line with the front speakers. To adjust
for other listening area arrangements, adapt delay times
according to the following:
Digital Surround
Measure the distances in centimeters from the front
speaker plane and from the surround speaker plane to the
listening positioning plane.
Subtract the surround distance from the front distance and
divide by 30. The result is the required Surround Channel
delay time in milliseconds.
If the center speaker is on the front speaker plane, no
center speaker delay is needed. If, however, it is nearer to
the listening position, measure the distance in centimeters
between the front and center speaker planes, and divide by
30. The result is the required Center Channel delay time in
milliseconds.
Digital Surround Delay
40
35
30
25
20
15
10
5
0
0 5 10 15 20 25 30 35 40
Distance from front speakers (feet)
Dolby Pro Logic
If the delay times for Surround Channel and Center
Channel are set for Digital Surround mode, the delay times
for Dolby Pro Logic mode will automatically be calculated
and set.
Pro Logic Surround Delay
40
35
30
25
20
15
10
5
0
0 5 10 15 20 25 30 35 40
Distance from front speakers (feet)
P
16
REPARATION
10 5
ms ms
0 ms
0 ms
0 ms
0 ms
-5 ms
-10 ms
Differential
arrival time
Preferred
Acceptable
Not recommended
25 20
ms ms
15 ms
15 ms
15 ms
15 ms
10 ms
5 ms
Differential
arrival time
Preferred
Acceptable
Not recommended
Connecting the power supply
1
Check if the power voltage as shown on the type plate (on
the back of the player) corresponds to your local power
voltage.
2
Plug the female end of the power cable supplied into the
Power connector POWER SUPPLY on the rear of the
player.
3
Plug the male end of the cord into an AC outlet.
Note:
– When the player is in the STANDBY or OFF position, it will
still consume some power.
– If you wish to disconnect your player completely from the
power supply, pull the plug from the AC Outlet.
Caution:
Only qualified service personnel should remove
the cover or attempt to service this device.
MA INS