Disc Playback - Philips DVP620VR/78 Owner's Manual

H9622MD(EN)1_46.qx4 04.4.8

18 Disc Playback

Before you begin, turn on the TV, Stereo, and other equipment
connected to the DVD/VCR. Make sure the TV and the Stereo (if
applicable) are set to the correct channel.
Details are on pages 6-14.
1
Press STANDBY-ON y y to turn on the DVD/VCR.
2
Press DVD so the DVD light appears on the front of
the DVD/VCR.
3
Press OPEN/CLOSE
the front of the DVD/VCR) to open the Disc tray.
4
Place a Disc into the tray. If the DVD is recorded on
only one side, place the Disc in the tray with the label
facing up and the shiny side facing down. Some DVDs are
recorded on both sides. Make sure the label of the side you
want to play is facing up.
5
Press PLAY B. The tray will close and play will begin at
the first Chapter or Track. If a DVD menu appears instead,
see page 47. With some Audio CDs, playback will not begin
unless you press PLAY B.
Or, press OPEN/CLOSE
DVD/VCR to close the tray.
With MP3 and JPEG files, playback will begin from the
beginning of the disc.
6
Press STOP C to stop playback.
Remember, this DVD/VCR
will play only certain Discs.
See page 5 for details.
5:03 PM Page 18
(to the left of the disc tray on
A
or press the tray toward the
A
STANDBY-ON
SEARCH MODE DISPLAY
REPEAT REPEAT AUDIO
A-B
SUBTITLE ZOOM ANGLE SKIP / CH
RETURN TITLE CLEAR/RESET SLOW
VCR VCR/TV DVD
DISC/VCR SYSTEM
MENU MENU
OK
6
STOP PLAY PAUSE
TIMER SET MARKER RECORD
3
Press OPEN/CLOSE A
on the DVD/VCR.
4
Insert a Disc.
Helpful Hints
• An "X" may appear at the top right
corner of the TV screen when you
try a feature. Either the feature is
not available on the Disc, or the
DVD/VCR cannot access the feature
at this time.This does not indicate a
problem with the DVD/VCR.
• If a Disc is dirty or scratched, the
picture may appear distorted or
playback may stop. Remove the Disc
and turn off the DVD/VCR.
Disconnect the power cord, then
reconnect it. Clean the Disc, then
turn on the DVD/VCR again and
reinsert the Disc for playback.
• When the DVD or CD light appears
on the display panel, the Disc is
loaded and ready for playback.
• When you press OPEN/CLOSE A or
PLAY (DVD) on the front of the
DVD/VCR when the power is off, the
DVD/VCR will turn on in DVD mode.
Otherwise, the DVD/VCR will turn on
in the mode in which it was turned
off.
1
2
5