ProTek R/C P-8 Instructions

Bag Contents

1 – Hauler Bag
1
– Tool Caddy
1
– Left Side Panel
1
– Right Side Panel
STEP 1 Assembly of Hauler Bag
1A) Remove bag from plastic, lay on flat surface with the front of the bag facing
upwards. Place left side panel (without notches) in bag with the top of the panel
underneath small plastic holder at top of bag. Slide lower portion of side panel
into position. Repeat for right side.
Note: Velcro gap on left side panel should be larger on top than on the bottom.
1B) Starting with the bottom shelf, secure the Velcro strip for shelf to left and
right side of hauler bag. Make sure to push the shelves as far back as possible
and attach to the Velcro strip to the rear of the bag. Fold down divider. Repeat
for top shelf.
1C) Completed hauler bag with shelves.
P-8 SUPER HAULER BAG INSTRUCTIONS
2 – Shelf Panels with Divider
6
– Medium Drawer End Caps (9 ½")
2
– Large Drawer End Caps (19 ½")
2
– Small Drawer End Caps (8")
1 – Large Drawer
3
– Medium Drawer
1
- Small Drawer