Using Component Video Jacks (Pr Pb Y); Using An Accessory Rf Modulator - Philips DVP3010/04 User Manual

Connections
S-VIDEO
VIDEO IN
COMPONENT VIDEO IN
S-VIDEO
IN
V (Pr/Cr) AUDIO
IN
U (Pb/Cb)
VIDEO IN
Y
1
IMPORTANT!
– The progressive scan video
quality is only possible when using Y
Pb Pr and a progressive scan TV is
required.
Using Component Video jacks
(Y Pb Pr)
1
Use the component video cables (red/
blue/ green) to connect the DVD system's
Y Pb Pr jacks to the corresponding
Component video input jacks (or labeled
as Y Pb Pr) on the TV (cable not supplied).
2
To hear the sound of this DVD Player
through your TV, use the audio cables
(white/red) to connect AUDIO OUT (L/
R) jacks of the DVD Player to the
corresponding AUDIO IN jacks on the TV
(cable not supplied).
3
Proceed to page 16 for detailed
Progressive Scan set up.
10
01-39 DVP3010_EU_04_2
COMPONENT
VIDEO IN
IN
V (Pr/Cr)
AUDIO
IN
U (Pb/Cb)
Y
2
10
RF coaxial cable to TV
2
Back of RF Modulator
(example only)
AUDIO IN
INT IN TO TV VIDEO
IN
R L
CH3 CH4
Antenna or
Cable TV signal
1
IMPORTANT!
– If your TV only has a single
Antenna In jack (or labeled as 75
ohm or RF In,) you will need an RF
modulator in order to view the DVD
playback on the TV. See your
electronics retailer or contact
Philips for details on RF modulator
availability and operations.

Using an accessory RF modulator

1
Use the composite video cable (yellow) to
connect the DVD Player's CVBS jack to
the video input jack on the RF modulator.
2
Use the RF coaxial cable (not supplied) to
connect the RF modulator to your TV's
RF jack.
04_8239 300 34302
20/12/2004, 10:09 AM