Getting Started; Step 1: Inserting Batteries; Using The Remote Control To Operate The System; Step 2: Finding Your Viewing Channel - Philips DVP5986K/96 User Manual

Step 1 : Inserting Batteries
A
Open the battery compartment.
B
Insert two batteries type R03 or AAA,
following the indications (+ –) inside the
compartment.
C
Close the cover.
CAUTION!
– Remove batteries if they are
exhausted or if the remote is not to
be used for a long time.
– Do not use old and new or
different types of batteries in
combination.
– Batteries contain chemical
substances, so they should be
disposed of properly.
Using the remote control to
operate the system
A
Aim the remote control directly at the
remote sensor (IR) on the front panel.
B
Do not put any objects between the
remote control and the DVD player
while operating the DVD player.
01-57_dvp5986K_98_eng2.indd 19 01-57_dvp5986K_98_eng2.indd 19

Getting Started

Step 2 : Finding your viewing
channel
Press STANDBY-ON 2 on the DVD
A
player to turn it on.
B
Turn on the TV and set it to the correct
video-in channel. You should see the blue
DVD background screen.
Usually these channel are between the
lowest and highest channels and may
be called FRONT, A/V IN, VIDEO.
See your TV's manual for more
details.
Or, you may go to channel 1 on your
TV, then press the Channel down
button repeatedly until you see the
Video In channel.
Or, the TV remote control may have
a button or turn that chooses
different video modes.
Or, set the TV to channel 3 or 4 if
you are using an RF modulator.
C
If you are using external equipment, (such
as audio system or receiver), turn it on
and select the appropriate input source
for the DVD player output. Refer to the
equipment user's manual for detail.
19
2007-04-02 11:47:07 AM 2007-04-02 11:47:07 AM