6
Follow the on-screen instructions to complete
the network installation.
»
Once connected, an IP address is obtained
automatically.
Tip
•
You can check the status of the wired connection of
this player (see “Adjust settings” > “Network Setup” >
[View Network Settings]).
Note
•
Loading BD-Live content from the internet may take
some time, depending on the file size and the speed of
the internet connection.
Use Philips EasyLink
This player supports Philips EasyLink which uses the
HDMI CEC (Consumer Electronics Control) protocol.
You can use one single remote control to control
EasyLink-compliant devices that are connected
through HDMI connectors.
Note
•
To enable the EasyLink feature, you must turn on the
HDMI CEC operations on the TV and on other devices
connected to TV. Refer to the TVs/devices manual for
details.
One-touch play
1
Press
(standby) to turn on this player.
»
The TV (if the TV supports one-touch play)
automatically turns on and switches to the
correct video-in channel.
»
If a disc is loaded, disc play automatically
starts.
One-touch standby
1
Press and hold
(standby) for more than 3
seconds.
»
All the connected devices (if the device
supports one-touch standby) automatically
switch to standby.
Note
•
Philips does not guarantee interoperability with other
HDMI CEC devices.
Page 12