Table of Contents
Advertisement
Audio setup
1
Press
.
2
Select [Setup], and press OK.
3
Select [Audio], and press .
Off
Video
Auto
Audio
Auto
Network
On
EasyLink
Preference
Advanced
4
Select an option, then press OK.
5
Select a setting, then press OK.
•
To return to the previous menu, press
.
•
To exit the menu, press
.
[Night Mode]
Increase a soft sound level such as dialogue to
make it easier to hear at a low volume, while
simultaneously decreasing a loud sound level.
•
[Auto] - Detect and select a best sound level
at a low volume. Applicable to tracks with
Dolby TrueHD audio only.
•
[On] – For quiet viewing at night.
•
[Off] – For surround sound with a full dynamic
range.
Note
•
Applicable only to Dolby encoded DVD-video or BD-
video.
[HDMI Audio]
Select an HDMI audio output when you connect
this player and the TV/audio device with an HDMI
cable.
•
[Bitstream] – If the connected HDMI
device supports the appropriate HD audio
decoder,the original audio format on the disc is
sent. Otherwise, LPCM is sent.
•
[Auto] – Detect and select the best supported
audio format automatically.
[Digital Audio]
Select an audio format for the sound output from
the DIGITAL OUT jack (coaxial/optical).
•
[Auto] - Detect and select the best supported
audio format automatically.
EN
•
[PCM] - The audio device does not support
multi-channel format. Audio is downmixed to
two-channel sound.
•
[Bitstream] - Select the original audio to
experience Dolby or DTS audio (BD-video
special sound effect is disabled).
Note
•
Ensure that the audio format is supported by the disc
and the connected audio device (amplifier/receiver).
•
When
[Bitstream] is selected, interactive audio like
button sound is muted.
[PCM Downsampling]
Set the sampling rate for PCM audio output from
the DIGITAL OUT jack (coaxial/optical).
•
[On] - PCM audio is down-sampled at 48kHz.
•
[Off] - For BD or DVD recorded in LPCM
without copyright protection, two-channel
audio signals up to 96 kHz are output as LPCM
signals with no conversion.
Network setup
1
Press
.
2
Select [Setup], and press OK.
3
Select [Network], and press .
Network Installation
Video
View Network Settings
Audio
Network
EasyLink
Preference
Advanced
4
Select an option, then press OK.
5
Select a setting, then press OK.
•
To return to the previous menu, press
.
•
To exit the menu, press
.
[Network Installation]
Install the network connection.
[View Network Settings]
Display the information for the current network
status.
Page 18
- Quick Links:
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
