Olympia L-7240 Installation And Maintenance

MAINTENANCE AND CARE INSTRUCTIONS

Olympia products are designed and engineered under strict quality standards. Regular and proper care of our
products will ensure years of trouble free service. To clean, simply wipe with a damp, soft cloth. Do not use
abrasive or harsh cleaners as they may result in finish damage. Regularly remove the aerator and clean any
debris inside it.

TROUBLE SHOOTING

A. If water leaks from the spout 1.
outlet:
2.
3.
4.
5.
B. If faucet has low flow: 1.
2.
C. If handles do not stop turning: 1.
2.
3.
4.

OLYMPIA FAUCETS, INC. LIMITED LIFETIME WARRANTY *

Olympia Faucets, Inc. warrants its products to the original consumer purchaser to be free from defects in material
and workmanship as long as the consumer purchaser owns it. Dated proof of purchase must accompany all war-
ranty claims. PVD finishes carry a lifetime warranty in residential service.
Olympia Faucets, Inc. will replace, free of charge, to the original consumer purchaser, any and all parts that
prove defective under normal installation, use, and service. Damage as a result of misuse, abuse, accident, or
improper installation, will consequentially void this warranty. Replacement parts can be obtained from your local
dealer or directly from Olympia Faucets. Olympia Faucets, Inc. recommends using a certified plumber for all
Faucet Installation and repair.
This warranty is limited to replacement of defective parts only. Incidental and consequential damages, labor
charges, repair, or replacement costs are expressly excluded. Some states do not allow the exclusion or limita-
tion of incidental or consequential damages, so the above limitation may not apply to you. This warranty gives
you specific legal rights, as you may have other rights of which vary from state to state.
Installation or maintenance and cleaning must be in compliance with instructions furnished with every Olympia
product. If you find a problem with your product, please immediately contact your nearest Olympia Faucets, Inc.
dealer or sales representative.
* 2 year limited warranty on commercial and multi-family projects.
Shut off both hot and cold water supplies.
Use 3/32" hex wrench to loosen handle set screw and
remove handles (A1,A2), bonnet nuts (B), and cartridges(C).
Check and replace springs and seats (D). If they are
damaged.
Reassemble handles (A1,A2), bonnet nuts (B), and
cartridges (C). NOTE: Make sure cartridge stops face
towards spout.
If seepage still occurs, replace cartridges (C).
Remove aerator, clean all internal debris, and make sure the
rubber washer is not damaged before tightening the aerator
back.
Repeat Trouble Shooting "A" and clean any debris trapped
in the seats and springs (D).
Shut off both hot and cold water supplies.
Remove handles (A1,A2) and bonnet nuts (B).
Check stops on cartridges (C) or inside handles (A) for
damages.
Replace necessary parts.
INSTALLATION AND MAINTENANCE
INSTRUCTIONS FOR OLYMPIA TWO HANDLE
LAVATORY FAUCET
THIS PRODUCT MEETS THE FOLLOWING STANDARDS: ASME A112.18.1 ~ ANSI
A117.1 ~ ANSI / NSF 61, SECTION 9 ~ UPC / IAPMO LISTED / ADA COMPLIANT ~
COMPLIES WITH CALIFORNIA LEAD PLUMBING LAW
PRODUCT NUMBERS
#L-7240 Lever Handles ~ With 50/50 Pop-Up
#L-7241 Lever Handles ~ Less Pop-Up
#L-7242 Lever Handles ~ With Brass Pop-Up
#L-7270
Lever Handles ~ With 50/50 Pop-Up
#L-7271 Lever Handles ~ Less Pop-Up
#L-7272 Lever Handles ~ With Brass Pop-Up
ADA
Olympia Faucets, Inc. © 2013