Rf Modulator Connection - Philips DVDR3506/37B Quick Start Manual

RF MODULATOR CONNECTION

If your TV has antenna in jack only, it is still possible to connect this unit to your TV by using a commercially available
stereo audio/video RF modulator. In this case, follow the instructions below.
1) Disconnect the power cords of the devices from the AC outlet.
2) Make the connection as illustrated below.
3) Set your RF modulator's channel 3/4 switch to either 3 or 4, whichever the TV channel is least used in your area.
If your RF modulator has a modulator/antenna switch, set it according to the manual supplied with the RF
modulator.
4) Plug in the power cords of the devices to the AC outlet.
5) Turn on your TV and choose the same channel as you set the RF modulator's channel 3/4 switch to.
For more details, follow the manual supplied with the RF modulator.
VHF / UHF
antenna
or
cable TV
company
Supplied cables used in this connection are as follows:
• RF coaxial cable x 1
• RCA audio cable (L/R) x 1
• RCA video cable x 1
Please purchase the rest of the necessary cables at your local store.
Note
• RF modulator is not supplied with this unit. You need to purchase it at your local store.
• The quality of picture may become poor if this unit is connected to an RF modulator.
14 14 EN EN
E7H42UD_DVDR3506-37_EN.indd 14 E7H42UD_DVDR3506-37_EN.indd 14
ANTENNA
IN
RF coaxial cable
OUT
ANTENNA
rear of your RF modulator
RF coaxial cable
Set channel 3 or 4
IN
VIDEO VIDEO
Y
IN OUT
L P /C
B B
L HDMI OUT
R
IN R P /C OUT COAXIAL
OUT R R
COMPONENT DIGITAL AUDIO OUTPUT
AV IN S-VIDEO AV OUT S-VIDEO
VIDEO OUTPUT PCM / BITSTREAM
VIDEO
OUT
L
RCA video
cable
R
AV OUT
RCA audio cable
ANT. IN
(not supplied)
3 4
R L
ANT. IN CHANNEL AUDIO IN VIDEO IN TO TV
rear of this unit
rear of your TV
RF coaxial cable
2007/12/28 10:52:51 2007/12/28 10:52:51