Fault Status Messages - Siemens RMB795B Basic Documentation

Common fault
status message
Text adjustments
Siemens
Building Technologies
If the RMB is operated in an interconnected device system with a line couple and is
in another area, the corresponding line couples must be set to "Route all" / "route"
(by the corresponding GeoZones).
16.5

Fault status messages

If the connection to 1 or several individual room controller is interrupted, a common
fault status message will appear for each room group:
No. Text
4503 Dev sup r grp 1
4513 Dev sup r grp 2
4523 Dev sup r grp 3
4533 Dev sup r grp 4
4543 Dev sup r grp 5
4553 Dev sup r grp 6
4563 Dev sup r grp 7
4573 Dev sup r grp 8
4583 Dev sup r grp 9
4593 Dev sup r grp 10
Based on this information, it can be checked on the Device supervision menu of
the relevant room group for the affected individual room controllers.
The fault status message texts are predefined. They can be adjusted via operation.
Main menu > Commissioning > Settings > Room group 1...10 ... or
Main menu > Settings > Room group 1...10 > Device supervision>
Operating line
Device supervision
room grp X
Central control unit RMB795B
Device supervision
Effect
Non-urgent message; must be acknowledged.
Non-urgent message; must be acknowledged.
Non-urgent message; must be acknowledged.
Non-urgent message; must be acknowledged.
Non-urgent message; must be acknowledged.
Non-urgent message; must be acknowledged.
Non-urgent message; must be acknowledged.
Non-urgent message; must be acknowledged.
Non-urgent message; must be acknowledged.
Non-urgent message; must be acknowledged.
Range
20 characters
Factory setting
Device supervision
R'g. X
129 / 144
CE1P3122en
18.01.2012