7.8.2.2
NK8237 connection check
7.8.3
NK83237 firmware download
Building Technologies
Fire Safety & Security Products
6. Drag and drop the selection to the appropriate Ethernet node.
A link node is created under the Ethernet node.
7. Select the BACnet Protocol link under the Ethernet node.
8. Drag and drop the selection to the NS8011 BACnet Driver node.
A link node is created under the driver node.
The NK8237 download requires that the TCP/IP connection between the engineer-
ing PC and the NK82xx is working properly. You can easily check this connection
using the Ping command; proceed as follows:
1. Run the Command Prompt.
From the Start menu:
Start Programs Accessories Command Prompt.
A black window appears.
2. Type: ping n.n.n.n <enter>,
with n.n.n.n being the 4-number IP address of the NK8237 unit.
3. Analyse the reply message.
If the IP connection is good, the message text looks like:
Reply from n.n.n.n: bytes=... time ... TTL="
If the IP connection is not working for any reason, different messages may ap-
pear (Request timed out, Destination net unreachable, etc.). In these cases,
verify the network settings and cabling and try again.
NK8237 firmware is made up by two parts:
1. NK823x_x.yy_Build_zz.zip
2. AddOn_NK823x_MODBUSGW_Build_zz.zip
and both of them must be downloaded in this order and in two separate steps.
Downloading a firmware update
1. Select the Download tab of the NS8011 Driver node.
2. In the Firmware list, select the version you want to download.
Note: You add and remove versions in the Firmware list by selecting them and
using the Add and Remove buttons.
3. Select the NK8237 in the list in the upper part of the form.
Note: In order to select multiple NK8237, keep the CTRL key pressed while you
make your selections.
4. Click the button Download Firmware.
The download procedure starts.
To ensure that the download completed successfully, verify that the FW
Downloaded checkbox contains an X.
After the download, the NK8237 unit stops and then reboots. The restarting phase
is monitored by the Composer tool.
Downloading the configuration file from the NS8011 driver node
1. Select the Download tab of the NS8011 Driver node.
2. Select a NK8237 unit (or more) in the list in the upper part of the form.
048_DMS_NK8237_ICC_MP4.40_A6V10316241_a_en.doc
Configuration
51
06.2011