Remove The Transit Bars; Commissioning Twindos - Miele WCI 860 Operating Instructions Manual

Before using for the first time

3. Remove the transit bars


Damage resulting from failure to
remove the transit bars.
Failure to remove the transit bars can
result in damage to the washing ma-
chine and to adjacent cabinetry or
appliances.
Remove the transit bars as described
in "Installation and connection".
The following message appears in the
display:

Remove transit bars
 Confirm with the OK sensor control.

4. Commissioning TwinDos

The UltraPhase 1 and UltraPhase 2 val-
ues are preset in the standard settings
and only need to be confirmed.
The following message appears in the
display:
 TwinDos
 Confirm with the OK sensor control.
The following message appears in the
display:
Set now
 To set up TwinDos now, touch the OK
sensor control.
 To postpone setup until later: touch
the  sensor control until the follow-
ing appears in the display:
and press OK to confirm.
20
Settings for compartment 
The UltraPhase 1 values are preset in
the standard settings.

 Confirm with the OK sensor control.
Miele UltraPhase 1
 Confirm with the OK sensor control.
The following appears in the display:
 Set the dosage. Observe water hardness
levels
 Confirm with the OK sensor control.
The dispensing quantity for
UltraPhase 1 is preset for  (hardness
level II).
Per load
 Confirm the preset value with the
OK sensor control. If you want to
change this value, use the
 sensor controls and confirm with
the OK sensor control.
 Hardness level I
 Hardness level II
Set later
 Hardness level III
 
Agent for 
 
 
 
 
 
UltraPhase 1
OK

OK
58 ml
OK
46 ml
58 ml
70 ml