Table of Contents
Advertisement
Before you start ...
Make sure the FM and AM/MW antennas
are connected.
Tuning to radio stations
A
Press SOURCE repeatedly until 'RADIO
FM' appears on the display panel (or
press RADIO on the remote control).
B
Press cursor left/right keys briefl y on the
remote control to start tuning.
'SEARCH > or <' appears on the
display panel until a radio station with
suffi cient signal strength is found.
C
B
Repeat step
if necessary until you fi nd
the desired radio station.
D
To fi ne-tune the reception of a weak
station, press the cursor up/down keys
briefl y and repeatedly until optimal
reception is found.
E
To switch between FM stereo and FM
mono mode, press AUDIO on the
remote control.
Changing tuning grid
(not available for all versions)
In some countries, the frequency step
between adjacent channels in the (AM/
MW)/ FM band is 9 kHz/ 50 kHz (10 kHz/
100 kHz in some areas).
Note:
Changing the tuning grid erases all
previously stored preset radio stations.
A
Press SOURCE repeatedly until 'RADIO
FM' or 'RADIO AM/MW' appears
B
Press STANDBY-ON to switch the
main unit to standby mode.
Radio Operations
C
Press STANDBY-ON again to power
up.
D
Press u until 'GRID 9' or 'GRID 10'
appears.
Presetting radio stations
You can store up to 40 FM and 20 AM
preset radio stations in the memory.
There are three different ways to
program the radio stations:
– Using auto install (for fi rst time setup
only)
– Using automatic preset
– Using manual preset
Helpful Hints:
– This unit exits presetting mode if no
button is pressed within 20 seconds.
– If no stereo signal is detected or less than
5 (fi ve) stations are detected during radio
installation, 'CHECK ANTENNA' appears.
Using auto install
When you access the 'RADIO' mode for
the very fi rst time, you will be prompted
to install the radio stations. With this
feature, you can install all the available
radio station automatically with one
touch of button.
RADIO
45
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
