Troubleshooting - Pioneer SVM-1000 Operating Instructions Manual

TROUBLESHOOTING

TROUBLESHOOTING
Incorrect operations are often mistaken for trouble and malfunctions. If you think there is something wrong with this component, check
the points below. Sometimes the trouble may originate from another component. Thus, also check the other electrical appliances also in
use.
If the trouble cannot be rectified even after checking the following items, contact your dealer or nearest PIONEER service center.
Symptom
No power.
No sound, or sound volume is
too low.
No microphone sound from
BOOTH output.
No digital output.
Sound is distorted.
Cross fader doesn't work.
Can't perform fader start with
DVD/CD player.
Effects don't work.
BPM can't be measured.
Measured BPM value is
incorrect.
The measured BPM value is
different from the value
published with the DVD/CD.
MIDI sequencer can't be
synchronized.
Possible Cause
• The power cord has not been connected.
• AUDIO INPUT switch is set incorrectly.
• Connection cables are not connected properly,
or are disconnected.
• Connentors or plugs are dirty.
• The rear panel MASTER ATT. switch is set to
–6 dB, etc.
• The OUTPUT TO BOOTH MONITOR (P. 42) is set
to OFF.
• The digital output sampling frequency (fs) does
not match the specifications of the connected
component.
• Audio master output level is too high.
• Input level is too high.
• CROSS FADER ASSIGN switch setting ([A],
[THRU], [B]) is incorrect.
• The FADER START button is set to OFF.
• Rear panel CONTROL connector is not
connected to DVD/CD player.
• Only the rear panel CONTROL connector is
connected to the DVD/CD player.
• Effect channel selecter (CH SELECT) setting is
incorrect.
• Effect parameter 2 dial (LEVEL/DEPTH) is set to
[MIN].
• Input level is too high, or too low.
• BPM may not be correctly measurable with
some tracks.
• Some differences may occur due to differences
in BPM detection methods.
• MIDI sequencer's synch mode is not set to
"slave".
• MIDI sequencer is not supported type.
Remedy
• Connect to power outlet.
• Set AUDIO INPUT switch to select the currently
playing component.
• Connect correctly.
• Clean away any dirt before connecting.
• Adjust rear panel MASTER ATT. switch.
• Set OUTPUT TO BOOTH MONITOR (P. 42) to ON.
• Set rear panel sampling frequency selector to
match the specifications of the connected
component.
• Adjust AUDIO MASTER LEVEL dial or the rear
panel MASTER ATT. switch.
• Adjust the AUDIO TRIM dial so that the input
level approaches 0 dB on the channel level
indicator.
• Correctly set the CROSS FADER ASSIGN switch
for the desired channel.
• Set the FADER START button to ON.
• Use a control cable to connect the CONTROL
connectors of mixer and DVD/CD player.
• Connect both the CONTROL connectors and
analog input connectors.
• Correctly select the channel on which you wish
to apply effects.
• Adjust the effect parameter 2 dial (LEVEL/
DEPTH).
• Adjust the AUDIO TRIM dial so that the input
level approaches 0 dB in the channel level
indicator.
• Adjust other channels as well so that the input
levels approach 0 dB in the channel level
indicator.
• Strike the TAP button to set BPM manually.
• No remedy is necessary.
• Set MIDI sequencer's sync mode to "slave".
• MIDI sequencers that do not support MIDI
timing clock cannot be synchronized.
45
En