Shutting Down; Transport; Storage; Care And Maintenance - Kärcher BDS 43/150 C Classic Manual

Shutting down

 Disconnect the mains plug from the
socket.
 Pull the lever for level adjustment.
 Move the handle into a vertical position.
 Release the lever for level adjustment.
 Remove the detergent tank (option) and
dispose of unused detergent solution.
 Wind the mains cable around the cable
hooks.
 Rinse the detergent tank (option) with
clear water.
 Place the appliance into the parking po-
sition.
 Remove the driver plate / disc brush.
 Clean the casing with a damp cloth.

Transport

CAUTION
Risk of personal injury or damage! Mind the
weight of the appliance during transport.
 Pull the lever for level adjustment.
 Move the handle into a vertical position.
 Release the lever for level adjustment.
 Tilt the appliance backwards into the
transport position and drive it to its des-
tination location.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.

Storage

CAUTION
Risk of personal injury or damage! Consid-
er the weight of the appliance when storing
it.
 Place the appliance into the parking po-
sition.
 Store the appliance in a dry room, frost-
protected room.

Care and maintenance

DANGER
Risk of injury. Pull the plug from the mains
before carrying out any tasks on the appli-
ance.
 Rinse contaminated disc brushes with
water.
6
 Wash contaminated pads at a max.
temperature of 60 °C.
 Clean the casing with a damp cloth.
 Check the mains connection cable for
damages.

Troubleshooting

DANGER
Risk of injury. Pull the plug from the mains
before carrying out any tasks on the appli-
ance.
In case of faults that cannot be remedied
using the table below please contact the
customer service.
Fault Remedy
Insuffi- Replace contaminated pads
cient and wash them at a max. tem-
cleaning perature of 60 °C.
result
Replace worn disc brush / pad.
Rinse contaminated disc
brushes with water
Check the suitability of brush/
pad and detergent for the re-
spective use.
Appliance Check for correct seating of
vibrates disc brush/pad.
strongly
Check pad attachment.
Position the handle lower
(arms outstretched).
Pad does Reset fuse of brush drive.
not turn
Check if foreign bodies are
blocking the brush/pad; re-
move the foreign bodies if re-
quired.
The warranty terms published by the rele-
vant sales company are applicable in each
country. We will repair potential failures of
your appliance within the warranty period
free of charge, provided that such failure is
caused by faulty material or defects in man-
ufacturing. In the event of a warranty claim
please contact your dealer or the nearest
authorized Customer Service centre.
Please submit the proof of purchase.
– 4
EN

Warranty