Setting the AS-i address of slave 2
Getting Started, 07/2016, FW V3.63, A5E38556288B AA
button; the display shows the text SEArcH followed
by uSE 0.
A small 0 is displayed to the left of the display and the number of
the first slave that has already been allocated to slave 1 is shown at
the bottom of the display.
button to select this number.
SEt 0 appears and the small 0 in the left of the display starts flash-
button until you reach the required number.
By pressing both the
identifiers of the address.
button to accept this number.
ProG is displayed briefly.
Both of the numbers allocated to the slaves are now displayed in
the lower part of the screen.
simultaneously, you can toggle between A and B
3.4 Using the AS-i Programmer