F2-JB-#.I, F*-JB-#.*
Maintenance of Cable Glands
1. Inner plastic piece
2. O-ring
3. Invert the cable shield over the inside plastic piece and shorten it to a length of 3 ... 4 mm
behind the O-ring.
1. O-ring
2. Inverted cable shield
3. Insert the cable wires with the inner plastic piece into the lower part of the cable gland.
4. Tighten the cap nut.
The tightening torques of cap nuts vary depending on the cable type used and must be
determined by the user. As a rule of thumb, the tightening torque is approx. 4.17 Nm for the
F*-JB**-... .CGB and CGS. See chapter 7.1.
30
1
2
1
2
3-4 mm