Table of Contents
Advertisement
19
HOW TO USE
HOW TO USE
Before use
Clean the refrigerator.
Clean your refrigerator thoroughly and wipe off all dust that accumulated
during shipping.
Do not scratch the refrigerator with a sharp object or use a detergent that
Remove adhesive residue by wiping it off with your thumb or dish detergent.
Connect the power supply.
Check if the power supply is connected before use.
Read the "Turning On The Power" section.
Turn off the icemaker if the refrigerator is not yet connected to
the water supply.
Plug the power plug of the refrigerator into the grounded electric outlet and then
OFF
* This is applicable only to certain models.
Wait for the refrigerator to cool.
Allow your refrigerator to run for at least two to three hours before putting food in it.
Check the flow of cold air in the freezer compartment to ensure proper cooling.
The refrigerator makes a loud noise after initial operation.
This is normal. The volume will decrease as the temperature lowers.
Open refrigerator and freezer doors to ventilate the interior.
The inside of the refrigerator may smell like plastic at first. Remove any adhesive
tape from inside the refrigerator and open the refrigerator and freezer doors for
ventilation.
CAUTION
contains alcohol, a flammable liquid or an abrasive when removing any tape or
adhesive from the refrigerator.
Do not peel off the model or serial number label or the technical information on
the rear surface of the refrigerator.
NOTE
turn off the automatic icemaker.
CAUTION
Running the automatic icemaker before connecting it to the water supply may
cause the refrigerator to malfunction.
CAUTION
Putting food in the refrigerator before it has cooled could cause the food to spoil, or
a bad odor could linger inside the refrigerator.
Advertisement
Table of Contents
