Vcr; To Select Connected Equipment - Philips 32DW9625/05 User Manual

TV

VCR

DVD SAT
DIGITAL
n
EXIT
GUIDE TEXT
æ
VCR
TV VCR DVD SAT
DIGITAL
n
GUIDE TEXT
DIGITAL
SELECT SETUP
OK
P
VCR
1 2 3
4 5 6
7 8 9
SETTINGS
0
S
SMART SMART
h
b Q

To select connected equipment

If the TV is connected to a video recorder with the EasyLink function, in some cases
the TV will be switched on, even when it was in standby. (E.g. playback tape,...)
This is not possible when Child Lock On is selected.
Equipment connected with an aerial cable only :
Select the programme number under which you have stored the test signal
with the digit keys.
Equipment connected to a euroconnector or to the right side of
the TV
Press the key repeatedly to select
according to where you connected your equipment at the back or the right
side of your TV.
Remark : Most equipment (decoder, video recorder, satellite receiver) carries out the
switching itself.
If you want to change to TV channels?
Enter the programme number of the TV channel which you want to watch
with the digit keys or press the
Audio- and video equipment keys
Most of the audio and video equipment from our range of products can be
operated with the remote control of your TV.
Press the , or
VCR DVD
operate with this remote control. See Use of the remote control, p. 15.
Video recorder
Press one of the video recorder keys after you pressed the
for record,
for rewind,
for stop,
for play,
for fast forward,
for selecting 1- or 2-digit programme numbers from the video
recorder,
- P + for sequential programme selection from the video recorder tuner,
0 to 9 to select a programme number from your video recorder tuner,
to switch the video recorder to standby
VCR timer
These keys function with equipment which use the RC5 signalling standard.
If your video recorder has the EasyLink function, the key
to stop the recording, under the door of the remote control, can be operated in
the TV mode.
If your EasyLink video recorder has the system standby function, when you press the
key for 3 seconds, both TV and the video recorder are switched to standby.
Connect Peripheral Equipment
,
EXT1 EXT2, EXT3
key.
TV
key according to the equipment you want to
SAT
or ,
FRONT
key:
VCR
for recording and the key
37