Advertisement
5. Preparing procedures & basic operation
TG-98STX
(1) Connect the main unit
Connect the DC INPUT in the rear panel of TG-98STX to an AC to DC adaptor.
(2) Basic operation
1. Connect the mixer output to the XLR / Ø6.3mm combo CH1 input at the rear panel
of TG-98STX with AF input cable.
2. Connect the gooseneck mic and gooseneck mic base at the XLR / Ø6.3mm combo
CH2 input at the rear panel of TG-98STX with AF input cable.
3. Connect the TG-98STX or CS-1CU at the Ø6.3mm mono CH3 input at the rear
panel of TG-98STX with AF cable as an source for interpretation.
NOTE 1:
Two balanced XLR / Ø6.3mm combo inputs are provided. You may use either one
input or both for a stereo source. Also, two balanced Ø6.3mm loop out connectors
are provided for multiple systems application.
TG-98STX
NOTE 2:
CH3 is an input signal only for monitoring through monitor headphone and will not be transmitted.
5
ST-5030i
CS-1CU
Monitor
CH1/CH2 CH3
CH1
CH2
GROUP
CHANNEL
or
AC to DC adaptor
XLR/Ø6.3mm COMBO INPUT
Advertisement
