Black & Decker 90518824 Instruction Manual page 9

90518824 CAN. CANNISTER VAC
VN2010/VN2200 - Mounting the Hard Surface Head (fig. A)
The Hard Surface Head (14) allows for vacuuming on wooden and polished surfaces.
• Press the lock button (21) and slide the tube (10) into the head (14) until it clicks into
place.
• To remove the head (14), press the lock button (21) and pull the tube (10) out of the
head.
VN2200/VN1400P - Mounting the Mini and Large Turbo Brush (fig. A 15a & 15b)
WARNING
The turbo brush (15a & 15b) allows for vacuuming on cut pile carpeting.
The brush is particularly useful for picking up hair, threads, etc., as well as for
refreshing trodden-down carpet pile.
• Press the lock button (21) and slide the tube (10) into the head (15a & 15b) until it
clicks into place.
• To remove the head (15a & 15b), press the lock (21) button and pull the tube (10) out
of the head.
Mounting accessories (fig. A)
The crevice tool (12) allows for vacuuming in narrow and hard to-reach places. The
brush tool (13) allows for vacuuming on furniture, blinds, curtains, windows and stairs.
The accessories can be mounted on both the hose (1) and the tube (10).
• Press the lock button (19 or 21) and slide the accessory onto the hose nozzle (20) or
the tube (10).
• To remove an accessory, press the lock button (19 or 21) and pull the accessory off.
When not in use, the accessories can be stored on the accessory holder (22). The
accessory holder is stored on the hose nozzle. This is clipped into place, to remove
pull way from the hose nozzle. The tools are stored as shown in fig. A.
Use
Unwinding and rewinding the cord
The cord rewind button (6) can be operated by hand or foot.
• Before use, pull a sufficient length of cord from the back of the appliance.
• After use, press the cord rewind button (6) to store the cord back into place. Manually
guide the cord to ensure it does not swing back. Ensure the plug is correctly located.
Adjusting the length of the tube (fig. B)
The extension tube (10) is made up of three pieces.
• To extend the middle / lower two pieces, press the lower adjustment button (23) and
slide out the tube fully until it clicks into place.
• The upper two pieces can be adjusted in 11 steps. Press the upper adjustment button
knob (24) and slide the tube to the desired length. Make sure that the tube clicks into
place.
Adjusting the suction head (fig. A)
• For vacuuming on carpets, switch the floor surface selector (25) into the up position.
• For vacuuming on laminates, tiles, etc., switch the floor surface selector (25) into the
down position.
Switching on and off
• The on/off switch (4) can be operated by hand or foot.
• To switch the appliance on, press the on/off switch (4).
• To switch the appliance off, press the on/off switch (4) again.
Adjusting the airflow (fig. B)
• Rotate the airflow control switch (11) to adjust the airflow as desired. Max and min
positions are shown.
10/28/08 10:40 AM Page 9
:
Injury to pets. Do not use directly on animals.
9