Getting Started - Electrolux E4WMSTPN1 Manual

Stain remover pen ultrasonic wave technology
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
5
5. GETTING STARTED (READ CAREFULLY)
Perform the colour fastness test below before using your Stain Remover Pen:
1. Moisten an inconspicuous area of the fabric with water.
2. Apply colourless liquid detergent.
3. Apply the Stain Remover Pen in this area following the instructions below.
4. Allow the fabric to dry. If it has not faded, you are clear to use your Stain
Remover Pen.
CAUTION!
The Stain Remover Pen will operate continuously for 5 minutes before it is switched
off to allow the tip to cool. After 4 and a half minutes of use, the wand tip will begin
to flash to indicate its maximum cycle time has nearly been reached.
After a 1 minute pause, the wand can again be used normally.
CAUTION!
Use only neutral and colourless liquid laundry detergent, which is chlorine-free.
Never use coloured detergents or fabric softeners, as they can stain the fabric.
CAUTION!
This product is designed to remove stains up to 3 cm (about 1 inch) in diameter.
It is not suitable for use on old stains or stains from chlorine bleaches, mustard,
non-removable inks, solvents and other chemicals causing permanent damage.
CAUTION!
If the care label on your clothes says "wash separately" or "wash with similar
colors", that usually means that the dye isn't stable and is going to bleed or even
rub off. You should wash your garment at least 3 times according to the care
label before to apply the Stain Remover Pen to avoid a possible halo effect on
unwashed dyed clothes. On darker fabrics reduce the application time.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents