Cypress Semiconductor CapSense CY3280-SLM Quick Start Manual

Arrow.com.
Downloaded from
CY3280-SLM UNIVERSAL CAPSENSE
1
1. Insert the kit CD in the CD drive.
2. Install the kit contents, PSoC Designer, and
PSoC Programmer.
3. The hardware prerequisites for this kit are the
CY3280-20x34* Universal CapSense Controller
(UCC) board and MiniProg1.
* Note The ordering part number for CY3280-20x34 UCC is
CY3280 - BK1.
3
1. Connect MiniProg1 to the CY3280-20x34
UCC Board's ISSP connector (J3). Connect it to
your PC using a USB cable.
2. Open PSoC Programmer and click File>File
Load. Browse and load the
CY3280_20x34_PD_Project1.hex file*.
3. Click Connect; connect MiniProg1 to PC.
4. Click Program button to program the device.
5. Click Toggle button to power the board.
*
Note These files are located at: <Install directory>
\Cypress\CY3280-SLM\<version>\Firmware
®
LINEAR SLIDER MODULE
KIT QUICK START GUIDE
2
1. Connect the CY3280-SLM board to the
CY3280-20x34 UCC board's P2 connector.
2. In the CY3280-20x34 board, place the
jumper on header J1 to short pins 2 and 3.
3. In the CY3280-SLM board, place the
jumper on header J2 to short pins 2 and 3.
4
1. Touch and move the linear slider on the
CY3280-SLM module board. The
corresponding LEDs on the CY3280-SLM
board light up.
2. Touch a button. The corresponding LED
on the CY3280-SLM module board lights
up.
3. You can touch multiple buttons at the
same time. The linear slider and buttons can
be used at the same time.