Presetting The Radio Stations; Listening To The Radio - Toshiba SD-C67HTSU Owner's Manual

Presetting the Radio Stations

You can preset 50 stations for AM (MW) and FM.
Before tuning, make sure that you have turned down
the volume.
1. Press AM/FM on the remote control until AM (MW)
or FM appears in the display window.
2. And then every time you press AM/FM, AM (MW)
or FM changes alternately.
3. Press and hold TUNE - or + on the remote control
or TUNING - or + on the front panel for about two
seconds until the frequency indication starts to
change, then release.
Scanning stops when the DVD Home Theater System
tunes in a station. "TUNED" and "ST." (for stereo
program) appear in the display window.
4. Press PROG on the remote control.
A preset number will flash in the display window.
5. Press PRESET v or V on the remote control to
select the preset number you want.
6. Press PROG on the remote control again.
The station is stored.
7. Repeat steps 3 to 6 to store other stations.
To tune in a station with a weak signal
Press TUNE - or + repeatedly in step 3 to tune in the
station manually.
To clear all the stored stations
Press and hold PROG for about two seconds and
"CLEAR ALL" is appeared in the display window and
then press PROG again, the stations are cleared.
If you have accidentally entered into the "CLEAR
ALL" mode and you do not wish to clear the
memory, do not press any key. After a few seconds,
the "CLEAR ALL" display will go off by itself and
change to normal mode.
Note:
If all stations have already been entered, the FULL
message will appear in the display window for a
moment and then a preset number will flash.
To change the preset number, follow the steps 5-6 as
above.

Listening to the Radio

Preset radio stations in the DVD Home Theater
System's memory first (see "Presetting radio stations"
on the left).
1. Press AM/FM until AM (MW) or FM appears in the
display window.
The last received station is tuned in.
2. Press v or V repeatedly on the remote control to
select the preset station you want.
Each time you press the button, the DVD Home Theater
System tunes in one preset station at a time.
3. Adjust the volume by rotating VOLUME on the
front panel or by pressing VOLUME + or - on the
remote control repeatedly.
To turn off the radio
Press POWER to turn the DVD Home Theater System
off or select another function mode (DVD/CD, AV 1,
etc.,).
To listen to non-preset radio stations
Use manual or automatic tuning in step 2.
For manual tuning, press TUNE - or + on the
remote control repeatedly.
For automatic tuning, press and hold TUNE - or +
on the remote control for about two seconds on the
front panel.
To select a preset radio station directly
You can use the number buttons on the remote
control to select a preset radio station directly.
For example, to listen to preset station 4, press 4 on
the remote control. To listen to preset station 19,
press 1 then 9 (within 3 seconds).
For your reference
If an FM program is noisy
Press MONO/STEREO on the front panel so that
"STEREO" disappears in the display window. There
will be no stereo effect, but the reception will
improve. Press MONO/STEREO on the front panel
again to restore the stereo effect.
To improve reception
Reorient the supplied antennas.
37