Viewing The Digital Signal Meter; Setting The Time Zone; Viewing The System Status - Toshiba 26AV502U Owner's Manual

Viewing the digital signal meter

You can view the digital signal meter in the ANT/CABLE
digital TV input source only.
To view the digital signal meter:
1�
Press and open the Setup menu.
2�
Highlight Installation and press
3�
A new set of Installation menu icons will appear, as
shown below. Open the Terrestrial menu, highlight
Signal Meter, and press
4�
Press pqtu to select the antenna input and digital
channel whose signal you want to check.
Note:
The physical digital channel number listed in the
•
Signal Meter screen may not correspond to a virtual
TV channel number. Contact your local broadcasters
to obtain the RF channel numbers for your local digital
stations.
The signal strength does not change between virtual
•
channels on the same physical channel.
To close the screen and return to the Terrestrial
menu:
Highlight Done and press
To return to normal viewing:
Press .

Setting the time zone

The Time Zone setup will allow you to specify the correct
time zone for your region. This feature will allow the TV
status information to show the correct time zone information
( page 50).
To set the time zone:
1�
From the Setup menu, highlight Installation and press
A new set of Installation menu icons will appear.
2�
Highlight Time Zone Setup, and press
3�
Press or to select the region, highlight Done, and
p q
then press .
After the time zone has been set, you will be asked to set the
current Daylight Saving Time status.
To set the Daylight Saving Time status:
1�
Press t or u to select Yes or No, highlight Done, and then
press .
Chapter 5: Setting up your TV
.
.
.
.

Viewing the system status

To view the system status:
1�
Press and open the Setup menu.
2�
Highlight Installation and press
3�
A new set of Installation menu icons will appear, as
shown below. Open the System Status menu, highlight
System Information, and press
4�
Press tu to scroll through the menu bar to select the
Software Version and view the related information.
To close the screen and return to the Installation
menu:
Highlight Done and press
To return to normal viewing:
Press .
Reset Factory Defaults
To reset all settings and channels to their factory
default values:
1�
Press and open the Setup menu.
2�
Highlight Installation and press
Installation menu icons will appear.
3�
Open the System Status menu, highlight System
Information, and press
4�
Press tu to scroll through the menu bar to select
Factory Defaults.
5�
Enter your PIN code (or 0000 if no PIN code has been set).
6�
Highlight Yes and press
automatically after a few seconds. After the TV turns off,
unplug the TV power cord and then plug it in again to
complete the reset process.
.
To cancel the reset:
Highlight No and press
.
.
.
. A new set of
.
. The TV will turn off
.