Spinning
Omitting the final spin (Rinse
hold)
Select the
Rinse hold
If Rinse hold is selected, the laundry
remains in the water following the final
rinse cycle. This helps to prevent
creasing if the laundry is not going to be
removed from the drum immediately
after the end of the programme.
Ending a programme with a spin
cycle
The wash programme is set to the
optimum spin speed. You can change
the spin speed.
Touch the
Change spin speed
control.
Select the desired spin speed.
Touch the Start/Stop sensor control
to start the final spin.
Ending a programme without a spin
cycle
Touch the
Change spin speed
control.
Select Spin speed
Touch the Start/Stop sensor control.
42
Extra.
sensor
sensor
(no spin).
0 rpm
Interim spin
There is a spin cycle after the main
wash and between the rinses. A
reduction in the final spin speed will
also reduce the interim spin speed as
appropriate.
Omitting the interim spin and
the final spin
Touch the
Spin speed
Select the
0 rpm
After the last rinse, the water will be
pumped away and the anti-crease
phase will switch in.
In some programmes an additional rinse
is introduced with this setting.
sensor.
setting.