Setting The Long Document Mode - Canon imageFORMULA DR-S150 User Manual

Hide thumbs Also See for imageFORMULA DR-S150:
Table of Contents

Advertisement

IMPORTANT
• Depending on the condition of the carrier sheet or passport, the
image may not be scanned completely or the scanner's image
correction may not function properly. If this is the case, set
[Page Size] to a larger paper size (A4, for example) on the
scanner driver settings screen, and then scan again.
p. 63)
• If the size of the passport differs greatly from the size of the
carrier sheet, a document jam may occur or the scanner's
image correction may not function properly.
• When scanning passports, set [Dots per inch] to 300 dpi or less
on the scanner driver settings
• The maximum thickness that can be scanned is 4 mm with the
passport inserted inside the carrier sheet. If the thickness
exceeds 4 mm, the scanner may break down due to problems
such as paper jam.
• Documents other than passports should not be inserted into the
carrier sheet and scanned. This may cause the scanner to
break down.
• Carrier sheet is a consumable item. Replace it with a new one
when necessary, if there are clear damages or smudges.

Setting the Long Document Mode

The length of documents that can be scanned with the scanner is
normally 356 mm (14"), but you can scan documents up to 3,000 mm
(118.1") long by setting the scanner to the Long Document mode.
IMPORTANT
By selecting the Long Document mode and setting the [Page Size]
on the scanner driver settings screen to Auto-detection, documents
of up to 3,000 mm (118.1") in length can be scanned. Note the
following when using the Long Document mode:
• When scanning in the Long Document mode, if the document is
placed on the scanner in a skewed position, it may hit the edges of
the feeding area and be damaged. Be careful to place the
document so that it is not skewed.
• When scanning with the Long Document mode, paper jam
detection may react slowly, resulting in damage to the document.
Be careful to avoid paper jams.
(See
screen.(See p. 63)
• When scanning long documents, make sure to set the feed
selection lever to Bypass mode, and scan the documents one at a
time.
• When scanning large-sized documents with the Long Document
mode, scanning may be slower. Errors also occur due to memory
shortage, and scanning may be disabled.
1
Open the scanner driver's Detail Settings screen.
p. 60)
2
Switch the scanner to Bypass mode.
3
In the [Basic] tab, click the [Setting] button of [Page Size]
[Page Size Settings] dialog box will open.
4
Click the [Long Document Mode] tab and specify the
Long mode.
Depending on the length of the document, select [Long Document
Mode (1000 mm)] or [Long Document Mode (3000 mm)].
33
(See
(See p. 27)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents