SETUP – SD-R6012
Toshiba recommends that only trained professionals install this DVD Rewriteable drive into your
The SD-R6012 DVD Rewriteable drive has no jumpers that need to be set
Mounting orientation: 15
(drive with volume control in up position).
When mounting drive use 4 M2-PO.4 tapping holes located on the left and right sides of drive.
When mounting drive, the tightening torque of the four screws must be even. Recommended
screw tightening torque is 2N
For clearance around the front bezel, it is recommended that a clearance of more than 0.8mm
should be left in all directions.
Toshiba's SD-R6012 drive does not require any unique device drivers for Windows '98/2000/XP/NT.
After installing your drive and re-booting, your system should recognize your drive. Win '98/2000/XP/NT
Operating Systems support all Toshiba's ATAPI drives natively. If you prefer using DOS, download the
ATAPI driver from our web site.
vertically (volume control in down position), 30°