Hints For Timer Recording - Toshiba D-RW2SU/D-RW2SC Owner's Manual

Hints for Timer Recording

• If there is a power failure or this unit has been unplugged for more than 30 seconds, the clock setting and all timer
programming will be lost.
• If a disc is not on the tray, the
indicator appears momentarily around the start point as the unit attempts to record. Please insert a recordable disc.
• When all the Timer Recording is completed, the
[I/y ON/STANDBY] first, and then press [PLAY B] or [OPEN/CLOSE A].
• During the Timer Recording or timer standby (
unit will not be available. To make these operations available, cancel the Timer Recording or timer standby first (
indicator disappears).
• To cancel the timer standby mode, press [I/y ON/STANDBY].
• When the Start and the End time are the same, the length of the recording will be set for 24 hours. When the disc
reaches the end during the recording, the unit turns itself off.
• When the programmed Start and End time are earlier than the current time, the setting will not be accepted and be
cleared for redoing.
• If the Start time is earlier and the End time is later than the current time, the recording will start right after you turn the
power off.
■ The priority of overlapped settings
This unit records the programs according to priority if the timer programmings are overlapped. The timer
programming set previously has priority.
A Timer Recording of lower priority will be canceled, start from the middle or stop on the way.
Check the overlapped timer programmings and change the priority if necessary.
■ A programming set previously has priority
When the starting time is same:
•
A program set previously (PROG. A) has priority.
PROG. A
PROG. B
Actual
PROG. A
recording
The first 30 seconds (approx.) will be cut off.
When the recording time is partially overlapped:
•
PROG. A will start after PROG. B is complete to be
recorded.
PROG. A
PROG. B
Actual
PROG.B
recording
The first 30 seconds (approx.) will be cut off.
■ Notes for DVD recording
• When the recording time of two programs are
overlapped, or the End time of a program and the Start
time of another is the same, the first 30 seconds
(approx.) of the subsequent program will be cut off.
• If the cut-off portion comes up to one minute or more,
this program will be displayed with error number E40 in
the timer programming list.
indicator flashes and Timer Recording cannot be performed. In some cases, the
indicator flashes. To play or eject the recorded disc, press
indicator will appear on the front panel display), any operations on the
•
PROG. B
•
PROG.A
•
When some programming have been made at
the end time of the programming currently
being recorded:
A program set previously (PROG. B) has priority.
PROG. A
PROG. B
PROG. C
Actual
PROG. A
recording
The first 30 seconds (approx.) will be cut off.
When the recording time is entirely overlapped:
PROG.A will be recorded.
PROG. A
PROG. B
Actual
PROG. B
recording
When the End time of the programming
currently being recorded and the Start time of
the subsequent program are same:
the beginning of the PROG. B may be cut off.
PROG. A
PROG. B
Actual
PROG. A
recording
The first 30 seconds (approx.) will be cut off.
PROG. B
PROG. B
EN 67