11.Connection
11.1. Power Supply Cable
(1) Housing
(2) Contact
(3) Cable Length
11.2. Interface Cable
(1) Connector
(2) Cable
Specific Impedance
Length
11.3. Audio Cable
(1) Capacitance
(2) Length
12.Emergency Eject
Execute following procedure only in the case of emergency (Tray will not eject and disc
can not be removed although pressing Eject Button).
(1) Turn the drive supplying power off.
(2) Insert solid bar (like paper clip) into Emergency Eject hole and push as shown in Fig.21.
Then Tray will be ejected.
(3) After removed the disc, gently push Tray to close.
50 mm
diameter 1.0 to 1.5 mm
Figurer 21 Insert the bar
AMP JAPAN P/N 1-480424-0 or equivalent
AMP JAPAN P/N 170148-2 or equivalent
AWG #28
Max. 2 m
ATAPI specification
40 core type
100 OHM +/-10 % (without shield)
Max. of 0.46 m for total ATAPI bus length
Unbalanced and shielded
Less than 1000 pF
Max. 3 m
26/29
SD-R5112 Rev.1.0