Advertisement

SETUP
Removing The Coravin System from the Box
• To remove your Coravin 1000 from the box, gently grasp the unit around the logo
and lift upwards.
• Peel back the protective packaging tape – this protects it from scuffing during
shipment.
• Carefully remove and discard the yellow covers on the spout and the needle.
These coverings are for shipping purposes only and are not needed to operate or
maintain the Coravin System. PLEASE BE CAREFUL – THE NEEDLE IS SHARP.
DISCARD
GETTING STARTED
DISCARD

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 1000 and is the answer not in the manual?

Questions and answers

Summary of Contents for CORAVIN 1000

  • Page 1 SETUP Removing the Coravin System from the Box • To remove your Coravin 1000 from the box, gently grasp the unit around the logo and lift upwards. • Peel back the protective packaging tape – this protects it from scuffing during shipment.
  • Page 2 INSERTING THE CAPSULE MAKE SURE the clamp is up to easily access the black cup that will contain the Coravin Capsule TWIST off capsule cup INSERT Coravin Capsule TWIST the cup back onto the unit quickly and tightly, then give it an extra half...
  • Page 3 ACCESSING THE BOTTLE PLACE bottle into a Coravin wine bottle sleeve and zip it closed In the down position SQUEEZE clamp and PLACE on bottle CHECK the needle to ensure it’s fully tighten into the system ENSURE needle guide is on...
  • Page 4 POURING THE WINE GRIP bottle with your dominant hand with spout facing the glass INSERT fingers of your other hand through the handle, leaving your thumb free TILT TILT bottle up as shown so the base of bottle is higher than spout NOTE: For best results, ensure spout is pointed...
  • Page 5 PRESS trigger (1/2 second) and quickly release to pour wine REPEAT when wine slows or stops NOTE: Longer trigger presses will be needed as the bottle empties. TILT bottle to upright position to stop pouring NOTE: Coravin may hiss, releasing excess pressure from bottle.
  • Page 6 REMOVING THE CORAVIN GRASP clamp firmly and PULL up on handle to remove needle SQUEEZE clamp to remove from bottle PLACE on stand and TAP trigger quickly (a fraction of a second) to clear any excess wine REMOVE wine bottle sleeve...
  • Page 7 CLEANING THE CORAVIN PLACE spout of the Cora- vin System under a small stream of warm water to rinse; allow water to flow out of needle DO NOT PRESS THE TRIGGER WHILE RINSING THE SPOUT. REMOVE from and PRESS trigger to release a...

Table of Contents