Black & Decker CV7205T Manual page 5

4. Filter cleaning wheel (CV9605S)
5. Charging indicator
6. Connector
7. Upper tube
8. Lower tube
9. Floor head
10. Brush actuator switches
Fig. A
11. Crevice tool
12. Brush tool
Installation
Fitting the charging base to the wall
(fig. B)
The charging base can be placed on a
worktop or fitted to the wall to provide
a convenient storage and charging point
for the appliance.
Assembly
Fitting the tubes and the floor head
(fig. C)
Fit the connector (6) on to the nose
x
of the appliance.
Fit the upper (7) and lower (8) tubes
x
together and attach the floor head (9)
to one end of the tube.
Attach the other end of the tube to
x
the connector on the nose of the
appliance.
Alternatively, to use as a hand-held
x
cleaner with brush on stairs and
furniture, attach the floor head
directly on to the connector.
Fitting the accessories (fig. A & D)
These models are supplied with the
following accessories:
- a crevice tool (11) for confined spaces
- a brush tool (12) for furniture and
stairs
To fit an accessory, proceed as follows:
Take the accessories from the
x
appliance.
Insert the appropriate accessory into
x
the front of the appliance.
ENGLISH
Use
Before first use, the battery must be
x
charged for at least 16 hours.
Place the appliance on the charging
x
base whenever it is not in use.
Charging the battery (fig. B)
Make sure that the appliance is
x
switched off. The battery will not be
charged with the on/off switch in the
on position.
Place the appliance on the charging
x
base as shown.
Plug in the charger. Switch on at the
x
mains.
The charging indicator (5) will be lit.
Leave the appliance to charge for at
x
least 16 hours.
Whilst charging, the charger may become
warm. This is normal and does not
indicate a problem. The appliance can be
left connected to the charger indefinitely.
The charging indicator will be lit as long
as the appliance is connected to the
plugged-in charger.
Warning! Do not charge the battery at
ambient temperatures below 4 °C or
above 40 °C.
Switching on and off (fig. E)
To switch the appliance on, slide the
x
on/off switch (1) forward.
To switch the appliance off, slide the
x
on/off switch back.
Optimising the suction force (fig. F)
In order to keep the suction force
optimised, the filter must be cleared
regularly during use.
Rotate the wheel (4) a few turns to
x
shake out dust clogging the filter (13).
Activating the brush
Use the switches (10) on the floor
x
head (9) to lower or raise the bristles
on the brush.
Lower the bristles for cleaning
x
carpets or rugs.
Raise the bristles for cleaning hard
x
floors, such as wood, tile or marble.
5