About Wireless LAN Connection
There are two methods to establish the wireless LAN connection.
1. Cofiguring the wireless network environment for the camera's wireless LAN
settings.
2. Cofiguring the camera's wireless LAN settings for the wireless network
environment.
The default settings of the network camera are as follows:
● Network information
Camera name
IP address
Subnet mask
● Wireless LAN settings
Connection mode
ESS-ID
Communication channel : Channel 10
WEP
■ Configuring the wireless network environment for
camera's wireless LAN settings
Install a wireless LAN board or wireless LAN card into your personal computer.
1) Turn on the power of the camera
NOTE
Ensure that the LAN cable is not inserted. If the LAN cable is inserted before
●
plugging in the camera, the network camera does not start in wireless LAN
mode.
2) Set the IP address of the personal computer
Set the IP address which you are not using other than 192.168.0.30
●
(camera's IP address).
・Set the IP address to 192.168.0.50 (and subnet mask to
255.255.255.0) as an example.
・ For details on the procedure, refer to the user's guide of the personal
computer.
3) Change the wireless LAN settings of the personal
computer
Set the same settings as "Wireless LAN settings" of the network camera.
●
・ For details on the procedure, refer to the user's guide of the installed
wireless LAN card/board.
: nwcam01
: 192.168.0.30
: 255.255.255.0
: Adhoc method
: ikwb
: None
27