Vitek Transcendent Series Quick Start Manual page 3

C onnecting A lar m I nput/O utput
A lar m I nput
A L A R M -I N
3
IPC
A L A R M -G N D 4
A lar m O utput
A L A R M -C O M
IPC
A L A R M -O P E N
Weather Resistant Network Coupler
1. Loosen the nut from the Weather Resistant Network Coupler.
2. Run ethernet cable through coupler, then attach a RJ-45 connector.
3. Tighten the nut and coupler for a weather resistant seal.
Installation
Before beginning installation, make sure that the wall or ceiling is
strong enough to withstand 3 times the weight of the camera. The
mounting steps are as follows:
1. Attach the drill template to
the place where you want to
install the camera, then drill
the screw holes and 1 cable
hole according to the drill
template.
2. Loosen the screws to open
the lower dome and then
loosen the lock screw to
remove the mounting base.
1
+
2
P ower S our ce
Sensor
+
A lar m
-
-
Lower Dome
3