Adding Channels To The Tv's Memory; Programming Channels Automatically - Toshiba 32AFX61 Owner's Manual

Adding channels to the TV's memory

When you press Channel y or z, your TV will stop only on the
specific channels stored in the TV's channel memory. Follow the steps
below and on the next page to program channels into the TV's
memory.

Programming channels automatically

Your TV can automatically detect all active channels in your area and
store them in its memory. After the channels are stored automatically,
you can manually add or erase individual channels. If you use both
ANT-1 and ANT-2 input sources, you must program channels for
each.
To program channels automatically:
1. Press MENU, and then press x or • until the SET UP menu
appears.
2. Press y or z until TV/CABLE is highlighted.
3. Press x or • to highlight either TV or CABLE, depending on
which you use. If you use an antenna, highlight TV. If you use
cable, highlight CABLE.
SET UP
LANGUAGE ENGL SH I
CLOCK SET
ANT 1 / 2 ANT1
TV / CABLE TV / CABLE
CH PROGRAM
ADD / ERASE ADD
0
T I LT CORRECT ON I
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35
4. Press z to highlight CH PROGRAM.
SET UP
LANGUAGE ENGL SH I
CLOCK SET
ANT 1 / 2 ANT1
TV / CABLE CABLE
CH PROGRAM
ADD / ERASE ADD
T I LT CORRECT ON I 0
5. Press x or • to start channel programming. The TV will
automatically cycle through all the TV or cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
"Programming Now—Please Wait" appears.
6. When channel programming is complete, the message
"Completed" appears.
7. Press CH y or z to view the programmed channels.
MENU
yzx •
CH yz
23
32/36AFX61(E)