Siemens SIMATIC NET CP 1411 Installation Instructions Manual page 35

Procedure in
Windows 98
Installationsanleitung CP 1411
C79000-Z8974-C24-05
To configure your CP 1411, follow the steps outlined below:
Step
1 Switch on your computer.
2 The CP 1411 is automatically detected and configured
when the operating system is started up.
3
This third step is only important when you want to
connect a TP cable to the CP 1411.
After installing the CP 1411 driver, you must activate TP in
the Windows Control Panel. Follow the steps outlined be-
low:
Step
1 Go to the Windows Control Panel and double-click
the "Network and Dial-up Connections" icon (taskbar
Start
2 Select the "Configuration" tab in the "Network and
Dial-up Connections" dialog.
3 In the list box "The following network components
are installed", select the CP 1411 by first selecting
the "Ethernet Adapter/ISA+ of the AMD PCNET
Family" and then click the "Properties" button.
Reaction:
The "Ethernet Adapter/ISA+ of the AMD PCNET
Family Properties" dialog box appears.
4 Select the "Advanced" tab and then select the entry
"TP" in the "Property" list box.
Reaction:
"Disabled" appears in the "Value" box on the other
side.
5 Select "Enabled" and confirm with "OK".
Reaction:
The "Network" dialog box appears.
6 Confirm with "OK".
Reaction:
The "System Settings Change" box appears.
7
7 To make the changes effective, click the "Yes" but-
ton and restart your computer.
Installation Instructions CP 1411
Procedure
Procedure
Settings Control Panel Network).
35