Advertisement
Available languages
Available languages
Produktgruppe 591
7 von 28
Fixing plinth to floor:
Danger!
Risk of toppling over. Risk of injury due to incorrect fitting.
With floor fastening, secure all four plinth feet.
Drill 4 holes 16 mm Ø approx. 90 mm deep in the floor as shown, see Fig. 4, Pos. B. Fig. 4 shows the section Fig. 3, Pos. A - A.
Insert 4 S16 Rawl plugs flush in the holes, see Fig. 5, Pos. 1.
Fit spacer plates as appropriate and use the spirit level to level the plinth, Fig. 5, Pos. 2.
Secure the plinth with 12 x 90 wood bolts, Fig. 5, Pos. 3, and B13 washers, Fig. 5, Pos. 4, to the floor.
Fitting the plinth under a washing machine:
Danger!
Risk of injury, particularly to the back. The relation of the weight of the machine to the physical strength of the technician must be
taken into account. For machine weight details, see the appropriate operating instructions.
Risk of crushing. When carrying out work, ensure that parts of the body, especially the hands and feet are not positioned under or
between machines.
Place the machine on the plinth.
Remove the machine feet, Fig. 6, Pos. 1.
Fit two M10 nuts on each M 10 threaded stud and counter them such that 15 mm ± 1 mm (10/16" ± 1/16") thread protrudes,
see Fig. 7.
Screw in the M10 threaded studs with the 15 mm (10/16") end into the washing machine and tighten them.
Fit a 10.5 washer on each threaded stud.
Fit the plinth and machine together.
From inside the plinth, fit a 10.5 washer on each threaded stud and then an M10 nut and screw tight.
Secure all 4 threaded studs in this manner.
Remove the transport struts.
Fitting the plinth under a tumble dryer:
Danger!
Risk of injury, particularly to the back. The relation of the weight of the machine to the physical strength of the technician must be
taken into account. For machine weight details, see the appropriate operating instructions.
Risk of crushing. When carrying out work, ensure that parts of the body, especially the hands and feet are not positioned under or
between machines.
Place the machine on the plinth.
Remove the machine feet, Fig. 6, Pos. 1.
Fit two M8 nuts on each M8 threaded stud and counter them such that 12 mm ± 1 mm (8/16" ± 1/16") thread protrudes, see Fig. 8.
Screw in the M8 threaded studs with the 12 mm (8/16") end into the tumble dryer and tighten them.
Fit an 8.5 x 30 x 3 washer on each threaded stud.
Fit the plinth and machine together.
From inside the plinth, fit an 8.4 washer on each threaded stud and then an M8 nut and screw tight.
Secure all 4 threaded studs in this manner.
Note
Fixing materials for a floating screed floor are to be provided on site.
Machine check:
Carry out appropriate safety checks.
Reconnect the machine to the mains.
Carry out a functional test either with the service programme or a wash programme.
Check the drain connection from the machine to the on-site drain in the floor or wall for leaks.
en
11.08.2010
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 07354421
Advertisement
