Table of Contents
Advertisement
PROBLEM
The answering
machine does not
answer the call.
Answering machine
does not play.
The messages are not
recorded/incomplete.
The answering
machine does not
respond to remote
operation.
The LED display shows
"A" (Announce only).
Can not delete
messages.
The phone does not
display the Caller ID/Call
Waiting data.
Auto talk and Any-key
feature do not work.
TROUBLESHOOTING
• The recording capacity is full.
→ Delete some or all of the recorded messages.
• No message is recorded.
→ This is normal.
• The message was too long or too short.
→ The message should not be longer than the recording
time (1 or 4 minutes), or shorter than 2 seconds.
• The recording capacity became full.
→ Delete recorded messages.
• The phone was answered during recording.
• The recording time is set to A (announce only).
→ Set the REC TIME to 1 or 4 minute setting.
• You are not calling from a touch tone phone.
→ Call from a touch tone phone.
• The security code (PIN) you entered was wrong.
→ Make sure you entered the correct security code (PIN).
→ If the answering machine is turned off, let the phone ring
at least 10 times. The line will connect and you will hear
several short beeps. Press
code (PIN).
• This is normal. The recording time is set to A (announce only).
→ Set the REC TIME to 1 or 4 minute setting.
• There is a message that has not been played.
→ Play the new message, then delete messages.
• You have to subscribe to Caller ID/Caller ID on Call Waiting services.
→ Check with your local telephone company.
• You answerd the call before Caller ID data was received.
→ Let the phone ring twice before you answer the call.
• The call is via PBX.
→ See page 26.
• The battery is not fully charged.
→ Charge the battery.
• Auto talk feature has been set to OFF.
→ Set this feature to ON. (Any-key feature automatically set to ON)
SOLUTION
and enter your security
#
45
Advertisement
Table of Contents
