Direct Wall Mounting - Toshiba DKT2304-CT User Manual

Installation
Step 6: (Optional) Wall Installation

Direct Wall Mounting

If you do not have a standard wall plate, you can mount your telephone directly on a
wall. Before mounting your telephone, consider the following:
Select a location away from electrical cables, pipes, or other items behind the
•
mounting location that could cause a hazard when inserting screws into the wall.
Make sure the wall material is capable of supporting the weight of the base unit.
•
Use #10 screws with anchoring devices suitable for the wall.
•
To wall mount the base unit
1. Insert two mounting screws 3-15/16 inches apart. Allow
about 3/16 of an inch between the wall and screw heads
for mounting the telephone (shown right).
2. Plug and secure the AC adapter cord by following Steps
2 and 3 of the
19.
3. Plug one end of the telephone line cord into the LINE
jack on the base unit. Optionally, plug one end of a Strata
DKT telephone into the PHONE jack. Then place the
telephone cord(s) inside the molded channel(s) on the
bottom of the wall mount stand.
4. Place the base unit on the posts of the wall screws
and push down until it's firmly seated.
5. Plug the other end of the telephone cord into a
telephone wall jack.
6. Plug the AC adapter into a standard 120VAC wall
outlet by following Step 7 of the Standard Wall
Plate Mounting.
20
"Standard Wall Plate Mounting"
Strata CIX and CTX DKT2204-CT/DKT2304-CT Cordless Digital Telephones
on page