Related Manuals for Toshiba SD-R2312
Summary of Contents for Toshiba SD-R2312
- Page 1 TOSHIBA AMERICA INFORMATION SYSTEMS STORAGE DEVICE DIVISION IRVINE, CALIFORNIA SD-R2312 CD-RW/DVD-ROM COMBINATION MOBILE DRIVE USER MANUAL...
-
Page 2: Table Of Contents
CONTENTS Introduction...1 Setup ...3 Using the CD-RW/DVD-ROM Combo Drive ...4 Troubleshooting...6 Specifications ...7 Drive Connectors...10... -
Page 3: Introduction
INTRODUCTION – SD-R2312 General Features CD-RW disc write/rewrite at 4X and 10X CD-R disc write at 8X – 24X Lead (Pb) Free Printed Circuit Board 3-way Disc Eject (eject button, software, emergency eject hole) Average Access Time 90ms DVD-ROM 100ms... - Page 4 Front Panel Figure 1.SD-R2312 CD-RW/DVD Combo Drive Front Panel Loading Load disc using tray. Tray Busy The LED lights green or amber when the drive is operating (LED is amber when drive is writing.) Indicator The Eject button is used to open the disc tray so you can install or remove a disc.
-
Page 5: Setup
Toshiba's SD-R2312 drive does not require any unique device drivers for Windows '98/2000/XP/NT. After installing your drive and re-booting, your system should recognize your drive. Win '98/2000/XP/NT Operating Systems support all Toshiba's ATAPI drives natively. If you prefer using DOS, download the ATAPI driver from our web site. -
Page 6: Using The Cd-Rw/Dvd-Rom Combo Drive
USING THE CD-RW/DVD-ROM Combo Drive – SD-R2312 Drive Operation Inserting Media To insert media perform the following steps: 1. Open the drive's loading tray by pressing the Eject Button and pulling out the tray. 2. Place media disc into drive's loading tray, and lightly press down on the inner portion of the disc. - Page 7 The SD-R2312 DVD-ROM/CD-RW drive supports the current RPC phase 2 industry specifications. This means that when the DVD-ROM drive ships from the factory it is set to the region for which the Operating System was intended.
-
Page 8: Troubleshooting
TROUBLESHOOTING – SD-R2312 Problem Disc tray cannot be opened Drive is not recognized by system Drive is not recognized by system during Boot process, recognized Operating System (i.e. XP, Win2000, Win98, Win NT, etc.) BUSY Indicator LED flashes slowly BUSY Indicator LED is... -
Page 9: Specifications
SPECIFICATIONS –SD-R2312 General Interface: ATAPI Compatible CD-RW/DVD-ROM Standard - Write Write Formats: Disc at once, Track at once, session at once, Packet Write CD-R, CD-RW: Write Disc: CD-DA, CD+(E)G, CD-MIDI, CD-TEXT, CD-ROM, CD-ROM XA, CD-R, CD-RW: MIXED MODE CD, CD-I, CD-I BRIDGE (Photo-CD, Video-CD), Multi-... - Page 10 Performance Rotational Speed DVD (Single) DVD (Dual) DVD-R, DVD-RW DVD-RAM (ver 2.1) DVD-RAM (ver 2.1) CD-ROM, CD-R Video-CD, CD-DA CD-DA CD-RW (read) - normal CD-RW (read) - high speed CD-R (write) CD-RW (write) CD-RW (write) - high speed Transfer Rate DVD (Single) DVD (Dual) DVD-RAM (Ver 2.1)
- Page 11 DC Voltage and Current Requirements Physical Height Width Depth Weight Connectors IDE Interface Connector Regulatory The SD-R2312 DVD Writeable drive has been certified by the following regulatory agencies: • UL 1950 • CSA C22.2 No. 950 • TUV (EN60950I) • CE standard •...
-
Page 12: Drive Connectors
Drive Connectors –SD-R2312 Figure 1.SD-R2312 DVD Writeable Drive Rear Panel – Connector ATAPI A 50-pin ATAPI interface connector is found at the rear of the SD-R2312 CD-RW/DVD- ROM Combo drive. Connecting cable should use Japan Aviation Electronics Industry Connector Limited KX14-50Series L or equivalent connector.